Monte-Carlo/Collision Probability Hybrid Method for LWR Fuel Assembly Burnup Calculations.
スポンサーリンク
概要
- 論文の詳細を見る
The continuous energy Monte-Carlo/collision probability hybrid method has been developed for efficient burnup calculations of light water reactor fuel assemblies. This hydrid method was applied to the NEACRP LWR fuel burnup benchmark, and the numerical results were in good agreement to those of the reference Monte-Carlo calculations in about 1/5 CPU time compared to the reference one, though there is a large difference between the results of RESPLA<SUP>(1)</SUP> (collision probability method) and VIM<SUP>(2)</SUP> (Monte-Carlo method). Thus this hybrid method is found to be effective for burnup calculations of light water reactor fuel assemblies.
- 一般社団法人 日本原子力学会の論文
著者
-
Kitada Takanori
Department Of Nuclear Engineering Graduate School Of Engineering
-
Takeda Toshikazu
Department of Nuclear Energy, Graduate School of Engineering, Osaka University
-
SAJI Etsuro
Toden Software Inc.
関連論文
- Brain metastasis of a papillary renal cell carcinoma, identified as type 2
- Prediction Accuracy Improvement of Neutronic Characteristics of a Breeding Light Water Reactor Core by Extended Bias Factor Methods with Use of FCA-XXII-1 Critical Experiments
- Measurement and Analysis of ^Am Fission Rate Ratio Relative to ^U Fission Rate in Thermal Neutron Systems Using Kyoto University Critical Assembly
- Measurement of^ Np Fission Rate Ratio Relative to ^U Fission Rate in Cores with Various Thermal Neutron Spectrum at the Kyoto University Critical Assembly
- Rapid Estimation of Core-Power Ratio in Coupled-Core System by Rod Drop Method
- Analysis of First-Harmonic Eigenvalue Separation Experiments on KUCA Coupled-Core
- Improvement of Fitting Method of Multiband Parameters for Cell Calculations
- Space and Angular Dependence of Interface Currents in the Multiband-CCCP Method
- Theoretical Study on New Bias Factor Methods to Effectively Use Critical Experiments for Improvement of Prediction Accuracy of Neutronic Characteristics
- Effect of Moderator Density Distribution of Annular Flow on Fuel Assembly Neutronic Characteristics in Boiling Water Reactor Cores
- Minor Actinides Incineration by Loading Moderated Targets in Fast Reactor
- Effective Convergence of Fission Source Distribution in Monte Carlo Simulation
- Effect of Radial Void Distribution within Fuel Assembly on Assembly Neutronic Characteristics
- Effective Cross Section of ^U Samples for Analyzing Doppler Effect Measurements in Fast Critical Assembly
- Evaluation of Eigenvalue Separation by the Monte Carlo Method
- Estimation of Error Propagation in Monte-Carlo Burnup Calculations
- Transport Calculations of MOX and UO_2 Pin Cells by the Method of Characteristics
- Parametric Study on Fast Reactors with Low Sodium Void Reactivity by the Use of Zirconium Hydride Layer in Internal Blanket
- Sensitivity Analysis for Multiplication Factor Change of LWR Cell Caused by the Differences between JENDL-3.2 and JENDL-3.3
- New Control Rod Homogenization Method for Fast Reactors
- An Improvement of the Transverse Leakage Treatment for the Nodal S_N Transport Calculation Method in Hexagonal-Z Geometry
- Effective Spatial Homogenization with Neutron Leakage Effect for FBR Control Rods
- Transumbilical approach for laparo-endoscopic single-site adrenalectomy : Initial experience and short-term outcome
- Extension of fission product model for use in lattice calculation of thorium fueled BWR.
- Neutron Anisotropic Scattering Effect in Heterogeneous Cell Calculations of Light Water Reactors
- Unified diffusion coefficient for analysis of sodium-void worth in fast critical assembly with control-rod channels.
- Effect of neutron leakage in cell calculations of fast critical assembly.
- Determination of effective diffusion parameters in thermal reactor assemblies.
- Monte-Carlo/Collision Probability Hybrid Method for LWR Fuel Assembly Burnup Calculations.
- Application of improved coarse mesh method to BWR core calculations.
- Application of depletion perturbation theory to fuel loading optimization.
- Approximate Calculation Method for Second Order Sensitivity Coefficient.
- Three-dimensional transport calculation method for eigenvalue problems using diffusion synthetic acceleration.
- Three-dimensional transport correction in fast reactor core analysis.
- Development of three-dimensional transport and diffusion codes based on nodal method.
- Fast Reactor of Negativ Na Void Reactiv and Its Transient Behavior.
- A New Nodal SN Transport Method for Three-Dimensional Hexagonal Geometry.
- Determination of cell averaged diffusion constants based on transport/diffusion perturbation theory.