Improvement of Fitting Method of Multiband Parameters for Cell Calculations
スポンサーリンク
概要
- 論文の詳細を見る
- Atomic Energy Society of Japanの論文
- 1997-07-25
著者
-
TAKEDA Toshikazu
Department of Urology, Keio University School of Medicine
-
KITADA Takanori
Department of Sustainable Energy and Environmental Engineering, Graduate School of Engineering, Osak
-
KURODA Mitsuo
Department of Nuclear Engineering, Graduate School of Engineering, Osaka University
-
Kuroda M
Osaka Univ. Osaka
-
Kuroda Mitsuo
Department Of Nuclear Engineering Graduate School Of Engineering Osaka University
-
Takeda Toshikazu
Department Of Nuclear Engineering Graduate School Of Engineering Osaka University
-
Kitada Takanori
Department Of Nuclear Engineering Graduate School Of Engineering
-
Kitada Takanori
Department Of Nuclear Engineering Graduate School Of Engineering Osaka University
-
Takeda Toshikazu
Department of Nuclear Energy, Graduate School of Engineering, Osaka University
関連論文
- Brain metastasis of a papillary renal cell carcinoma, identified as type 2
- Prediction Accuracy Improvement of Neutronic Characteristics of a Breeding Light Water Reactor Core by Extended Bias Factor Methods with Use of FCA-XXII-1 Critical Experiments
- Measurement and Analysis of ^Am Fission Rate Ratio Relative to ^U Fission Rate in Thermal Neutron Systems Using Kyoto University Critical Assembly
- Measurement of^ Np Fission Rate Ratio Relative to ^U Fission Rate in Cores with Various Thermal Neutron Spectrum at the Kyoto University Critical Assembly
- Rapid Estimation of Core-Power Ratio in Coupled-Core System by Rod Drop Method
- Analysis of First-Harmonic Eigenvalue Separation Experiments on KUCA Coupled-Core
- Improvement of Fitting Method of Multiband Parameters for Cell Calculations
- Space and Angular Dependence of Interface Currents in the Multiband-CCCP Method
- Theoretical Study on New Bias Factor Methods to Effectively Use Critical Experiments for Improvement of Prediction Accuracy of Neutronic Characteristics
- Effect of Moderator Density Distribution of Annular Flow on Fuel Assembly Neutronic Characteristics in Boiling Water Reactor Cores
- Nonlinear Behavior under Regional Neutron Flux Oscillations in BWR Cores
- Spatial-harmonic Neutron Spectrum Effect on Frequency-domain Modal Analysis of Regional Stability in BWR
- Minor Actinides Incineration by Loading Moderated Targets in Fast Reactor
- Effective Convergence of Fission Source Distribution in Monte Carlo Simulation
- Effect of Radial Void Distribution within Fuel Assembly on Assembly Neutronic Characteristics
- Reaction Rate Calculation in Fast Reactor Blanket Using Multiband S_n Theory
- Effective Cross Section of ^U Samples for Analyzing Doppler Effect Measurements in Fast Critical Assembly
- Evaluation of Eigenvalue Separation by the Monte Carlo Method
- Neutron Anisotropic Scattering Effect in Heterogeneous Cell Calculations of Light Water Reactors
- Estimation of Error Propagation in Monte-Carlo Burnup Calculations
- Transport Calculations of MOX and UO_2 Pin Cells by the Method of Characteristics
- Parametric Study on Fast Reactors with Low Sodium Void Reactivity by the Use of Zirconium Hydride Layer in Internal Blanket
- Sensitivity Analysis for Multiplication Factor Change of LWR Cell Caused by the Differences between JENDL-3.2 and JENDL-3.3
- New Control Rod Homogenization Method for Fast Reactors
- An Improvement of the Transverse Leakage Treatment for the Nodal S_N Transport Calculation Method in Hexagonal-Z Geometry
- Effective Spatial Homogenization with Neutron Leakage Effect for FBR Control Rods
- Transumbilical approach for laparo-endoscopic single-site adrenalectomy : Initial experience and short-term outcome
- Extension of fission product model for use in lattice calculation of thorium fueled BWR.
- Neutron Anisotropic Scattering Effect in Heterogeneous Cell Calculations of Light Water Reactors
- Unified diffusion coefficient for analysis of sodium-void worth in fast critical assembly with control-rod channels.
- Effect of neutron leakage in cell calculations of fast critical assembly.
- Determination of effective diffusion parameters in thermal reactor assemblies.
- Monte-Carlo/Collision Probability Hybrid Method for LWR Fuel Assembly Burnup Calculations.
- Application of improved coarse mesh method to BWR core calculations.
- Application of depletion perturbation theory to fuel loading optimization.
- Approximate Calculation Method for Second Order Sensitivity Coefficient.
- Three-dimensional transport calculation method for eigenvalue problems using diffusion synthetic acceleration.
- Three-dimensional transport correction in fast reactor core analysis.
- Development of three-dimensional transport and diffusion codes based on nodal method.
- Fast Reactor of Negativ Na Void Reactiv and Its Transient Behavior.
- A New Nodal SN Transport Method for Three-Dimensional Hexagonal Geometry.
- Determination of cell averaged diffusion constants based on transport/diffusion perturbation theory.