A Simulation Experiment of the Results of Fission Product Gas Release due to Fuel Cladding Failure using Water Circulation System
スポンサーリンク
概要
- 論文の詳細を見る
To examine the effects of fission product gas release into the coolant channel due to fuel cladding failure, two preliminary simulation experiments were undertaken using an electrical heater pin set in a system for water circulation. The first experiment represented a continuous release of gas from a small hole in the cladding, and the second a sudden burst of gas into the system due to plenum rupture. The first experiment revealed that the cladding surface temperature registered a sharp dip at the stagnation point of the water flow created immediately upstream of the gas releasing hole and that the temperature at the bottom of the dip was very sensitive to the ratio between the gas release rate and water flow rate. In the second experiment, representing plenum rupture, a pressure pulse of about 8 kg/cm<SUP>2</SUP> was registered on the wrapper tube, and the cladding surface temperature was found to rise by about 10°C within 0.1 sec (with heating at 100 W/cm), due to gas blanketing. The magnitude of the deformation and the transient strain on the cladding surface were also measured.
- 一般社団法人 日本原子力学会の論文
著者
-
Oyama Akira
Department Of Space Transportation Engineering Institute Of Space And Astronautical Science Japan Ae
-
Kondo Shunsuke
Department Of Applied Chemistry Graduate School Of Engineering Nagoya University
-
AN Shigehiro
Department of Nuclear Engineering, Faculty of Engineering, University of Tokyo
-
MIYAGUCHI Kimihide
Plutonium Fuel Division, Power Reactor and Nuclear Fuel Development Corporation
-
AN Shigehiro
Department of Nuclear Engineering, University of Tokyo
-
OYAMA Akira
Department of Nuclear Engineering, Faculty of Engineering,the University of Tokyo
関連論文
- A Numerical Analysis of Molten Metal Drop and Coolant Interaction
- The Change of Memory Formation According to STDP in a Continuous-Time Neural Network Model
- Synthesis and Chiral Recognition of Novel Regioselectively Substituted Amylose Derivatives
- New Constraint-Handling Method for Multi-Objective and Multi-Constraint Evolutionary Optimization
- A CONCEPTUAL DESIGN OF LIB FUSION REACTOR : UTLIF (2)
- Computational Study of Effects of Nondimensional Parameters on Synthetic Jets
- Measurement of Heat Transfer Coefficients for Axial Air Flow through Eccentric Annulus and Seven-Rod Cluster
- Calculation of the Spin- and Energy-Dependent Fission Widths for 233U, 235U, 239Pu and 241Pu from Channel Theory
- Effect of Spin-Dependence of Fission Width of 239Pu on Self-Shielding and Doppler Effects
- A Simulation Experiment of the Results of Fission Product Gas Release due to Fuel Cladding Failure using Water Circulation System
- On the Two-Point Approximation Equation of Reactor Kinetics
- Calculation of the Spin and Energy Dependence of the Fission Width for U-235 and Pu-239
- A Matrix Operator Method for Reactor Calculation
- An application of conversational procedure to optimization of multi-layer radiation shielding design.
- Regression Model for Nuclear Characteristics of Sodium-Cooled Fast Reactor Core
- Neutronics calculations in pellets and blankets of laser fusion reactor concept SENRI-I.
- Dynamic Analysis of Large Fast Reactor
- Effects of Multiple Control Rods
- Optimization of refueling scheme of sodium-cooled fast reactor core using heuristic enumeration method.
- Application of Sequential Unconstrained Minimization Technique to LMFBR Core Design Optimization Problem
- Development of radiation transport code in three-dimensional (X, Y, Z) geometry for shielding analyses by direct integration method.
- Clinical impact of c-Met expression and its gene amplification in hepatocellular carcinoma