Heat transfer in jet mixing vessel with rotating nozzle around the vessel axis.
スポンサーリンク
概要
- 論文の詳細を見る
Measurement of the heat transfer coefficient at the vessel wall was made in a jet mixing vessel with rotating nozzle around the vessel axis. The observed heat transfer coefficient was correlated with power input per unit volume, and the resultant correlation equation at low nozzle rotation speed roughly agreed with that for an agitated vessel with anchor. The heat transfer coefficient at higher nozzle rotation speed decreased with increase of the nozzle rotation speed (i.e., the innerr shaft rotation speed) and approached that for coaxial rotating cylinders. Baffle plates in the jet mixing vessel did not improve the heat transfer coefficient.
- The Society of Chemical Engineers, Japanの論文
著者
-
HIRAOKA Setsuro
Department of Applied Chemistry, Nagoya Institute of Technology
-
Yamada Ikuho
Department Of Applied Chemistry Nagoya Insitute Of Technology
-
Tada Yutaka
Department Of Life And Material Engineering Nagoya Institute Of Technology
-
Aragaki Tsutomu
Department of Appfied Chemistry, Nagoya Institute of Technology
-
Koh Seung
Department of Applied Chemistry, Nagoya Institute of Technology
-
Takahashi Takaaki
Department of Applied Chemistry, Nagoya Institute of Technology
-
Suzuki Kiyotaka
Department of Applied Chemistry, Nagoya Institute of Technology
-
Tada Yutaka
Department of Applied Chemistry, Nagoya Institute of Technology
関連論文
- PHASE EQUILIBRIA AND SIMULATION METHOD FOR HETEROGENEOUS AZEOTROPIC DISTILLATION
- Calculation of Three-Phase Flash and Partial Condensation for Ternary Systems
- A Method of Calculating Multistage Liquid-Liquid Extraction for Ternary Systems
- Solid-Liquid Mass Transfer in Gas-Liquid-Solid Agitated Vessel
- Low-Frequency Fluctuations in Agitated Vessels
- Simplified Heat and Mass Transfer Model for Distillation Column Simulation
- Total Reflux Simulation of Packed Column Distillation
- PACKED COLUMN DISTILLATION SIMULATION WITH A RATE-BASED METHOD
- THERMODYNAMIC FACTORS DERIVED FROM GROUP CONTRIBUTION ACTIVITY COEFFICIENT MODELS
- Singular Finite Elements for the Die-Swell Simulation of Viscoelastic Fluids
- Practical Correlation of Excess Molar Volumes of Binary, Ternary and Quaternary Mixtures of Water, Methanol, Ethanol and 1-Propanol by an NRTL-Type Equation
- Application of a Singular/Decoupled Finite Element Method to the Viscoelastic Die-swell Flow Simulation
- NUMERICAL ANALYSIS OF TURBULENT FLOW AND HEAT TRANSFER IN PARALLEL PLATES ATTACHED WITH TURBULENCE PROMOTERS AT REGULAR INTERVALS ON LOWER SURFACE
- Transport Phenomena around Cylindrical Baffles in an Agitated Vessel Measured by an Electrochemical Method
- Effects of Liquid Film Formed on Flask Surface on Oxygen Transfer Rate in Shaking Flask and Development of Baffled Shaking Vessel by Optical Method Based on Sulfite Oxidation
- Mixing Performances of a New Mixing Equipment with Vibratory Fins
- Model Analysis of Mixing Time Correlation in an Agitated Vessel with Paddle Impeller
- The Superstring Action with General Reparametrization Symmetry : Particles and Fields
- Brans-Dicke Theory from M_4×Z_2 Geometry
- A MODIFIED BROYDEN-HOUSEHOLDER ALGORITHM FOR SOLVING MULTICOMPONENT DISTILLATION PROBLEMS
- Estimation of Heat Transfer Coefficient from Universal Expression of Tangential Velocity at Boundary Layer Edge on Side Wall of a Fully Turbulent Agitated Vessel
- Estimation of Boundary Layer Thickness at Side Wall of a Fully Turbulent Agitated Vessel without Baffles
- Universal Expression of Tangential Velocity Distribution near Side Wall of a Fully Turbulent Agitated Vessel without Baffles
- Estimation of Tangential Velocity near Side Wall of Fully Turbulent Agitated Vessel without Baffles
- Prediction of Mixing Pattern by Using Power Number Diagram in Baffled and Unbaffled Mixing Vessels
- Performance of a Shaking Vessel-Type Bioreactor with a Current Pole
- IMPROVEMENT OF PARTICLE DISPERSION IN A SHAKING VESSEL WITH CURRENT POLE
- GAS-LIQUID TURBULENT TWO PHASE FLOW ALONG VERTICAL FLAT PLATE WITH GAS EVOLUTION
- A STAGEWISE ALGORITHM FOR MULTICOMPONENT MULTISTAGE BATCH DISTILLATION CALCULATION
- Power Consumption and Gas-Liquid Mass Transfer Volumetric Coefficient in an Agitated Vessel with Pitched Wire-Gauze Blade Impeller under Aeration
- Correlation of Discharge Flow Rate in a Vessel with Pitched Blade Paddle Impeller
- Independent component-cross correlation-sequential epoch (ICS) analysis of high field fMRI time series: direct visualization of dual representation of the primary motor cortex in human
- High-field (3.0 T) functional MRI sequential epoch analysis: an example for motion control analysis
- Rapid Electroconcentration in a Tube of 25-40 Microliters under a Relatively Low Applied Voltage
- Enhanced Anthocyanin Production from Grape Callus in an Air-Lift Type Bioreactor Using a Viscous Additive-Supplemented Medium
- Mixing Performance of an Agitated Vessel with Bottom Baffles
- Solid-Liquid Mass Transfer and Critical Frequency for Complete Suspension in a Reciprocally Shaking Vessel
- Mixing Performance of a Reciprocally Shaking Vessel
- ACCELERATING CONVERGENCE IN SUCCESSIVE RELAXATION ALGORITHM FOR MULTICOMPONENT DISTILLATION CALCULATION
- Enhancement of Sonochemical Reaction with the Addition of Aluminum Powder in a Sonoreactor
- Correlation of Power Consumption for Propeller and Pfaudler Type Impellers
- Effects of Sparger Geometry on Power Consumption and Mass Transfer in a Gas–Liquid Agitated Vessel with Disk Turbine
- Effect of Ultrasonic Irradiation on Chemical Reaction in Iodine Solution Decolorization Experiment
- Improvement of Mixing Efficiencies of Conventional Impeller with Unsteady Speed in an Impeller Revolution
- Influence of Neuroticism on Denture Wear
- VAPORIZATION FROM PURE LIQUID SURFACE IN A CENTRIFUGAL MOLECULAR STILL
- Effect of Mixing on Sonochemical Reaction in a Sonoreactor
- Effects of Sparger Geometry on Power Consumption and Mass Transfer in a Gas-Liquid Agitated Vessel with Disk Turbine
- MASS TRANSFER VOLUMETRIC COEFFICIENT AND DROPLET DIAMETER IN LIQUID-LIQUID DISPERSIONS STIRRED WITH A PADDLE IMPELLER WITH WIRE GAUZE
- Hydrodynamics and Power Consumption of Rotating Baffled Shaking Cylindrical Vessel
- Effects of Reflection Plate on Ultrasonic Reaction in a Sonoreactor
- Power Consumption and Gas - Liquid Mass Transfer Volumetric Coefficient in a Mechanically Agitated Vessel with Wire - Gauze Impeller
- Low-Frequency Fluctuations in Agitated Vessels
- Distillation calculation by use of conjugated gradient method.
- Simulation of a multieffect solar still and the static characteristics.
- Heat transfer in jet mixing vessel with rotating nozzle around the vessel axis.
- Jet mixing of liquids in a rotating cylindrical vessel.
- Measurement of mass transfer rate from free surface in shaking vessel type bioreactor.
- Jet mixing of liquids with a rotating nozzle around the axis of a cylindrical vessel.
- Generalized relation between liquid pressure and solid compressive pressure in non-unidimensional filter cakes.
- Concentration dependence of diffusivity for the styrene-polystyrene and ethylbenzene-polystyrene systems.
- Combined free and forced laminar convection in thermal entrance region of horizontal triangular ducts.
- The effect of variable viscosity on laminar flow and heat transfer in rectangular ducts.
- Effects of Position and Geometry of Current Pole on Mixing Characteristics in Shaking Vessel
- Production of Regenerated Plantlet using Shaking Vessel-Type Bioreactor.
- Constant pressure filtration of power-law non-newtonian fluids.
- Distillation calculation by multistage relaxation methods.
- APPROXIMATION FOR PREDICTION OF VAPORIZATION PLATE EFFICIENCY
- PREDICTIONS OF CONSTANT PRESSURE AND CONSTANT RATE F1LTRATIONS BASED UPON AN APPROXIMATE CORRECTION FOR SIDE WALL FRICTION IN COMPRESSION PERMEABILITY CELL DATA
- Development of jet mixer with rotating and up-and-down moving nozzles.
- Vaporization of non-ideal binary mixture from liquid surface under vacuum.
- Mutual diffusivity of volatile materials in molten polystyrene.
- Theoretical analysis of turbulent flow and heat transfer around a surface-mounted obstacle.
- Optimum operating condition of Petlyuk's distillation process for ternary separation.
- A method for solving design problem of multicomponent distillation.
- Experimental study on heat transfer of combined free and forced laminar convection in thermal entrance region of horizontal rectangular ducts.
- Combined free and forced laminar convection in triangular ducts.
- Heat transfer under solidification of liquid on agitated vessel wall.
- Constant rate and variable pressure-variable rate filtration of power-law non-newtonian fluids.
- Industrial expression equation for semisolid materials of solid-liquid mixture under constant pressure.
- POROSITY VARIATION IN FILTER CAKE UNDER CONSTANT-PRESSURE FILTRATION
- Numerical analysis of three dimensional velocity profile of highly viscous Newtonian fluid in an agitated vessel with paddle impeller.
- Blocking filtration laws for filtration of power-law non-newtonian fluids.
- Analysis of constant pressure filtration of power-law non-newtonian fluids.
- Visualization of jet flow in a mixing vessel with a nozzle rotating around the vessel axis.
- Heat Transfer Coefficient and Mixing Time in a Cylindrical Mixing Vessel with Axial Jet Nozzles
- Analysis of heat and mass transfer in a centrifugal molecular still.
- NOTE ON ABSORPTION POINT EFFICIENCIES
- LAW OF THE WALL AND VELOCITY DEFECT LAW IN FULLY TURBULENT NON-BAFFLED AGITATED VESSEL
- Numerical method for solving steady three-dimensional heat conduction problem in sector column.
- TRANSPORT PHENOMENA AT THE WALL OF AGITATED VESSELS
- Evaluation of psychological effect of prosthetic treatment using Emotion Spectrum Analysis Method (ESAM)