卒業研究「可搬形手動ウインチの設計と製作」を通した実践的教育

概要

論文の詳細を見る
At design and drawing lecture "Design of a manual operation winch", almost all students have been performing thetask in the state where they have never seen any actual winch. If students can see a winch during the lecture,it seems thatit is immensely effective for students. Then,we have tried practical education through graduation study "Design andmanufacturing of a portable and manual operation winch". The winch design specification is follows: hoisting loadcapacity 200N,winding length 2m and target weight 50N. Gears for gear reducer were selected from a commercial gearcatalogue. We many times consulted with the peers and undergraduates in the same laboratory or the robot laboratory. Thestudent could realize the difficulty of design and manufacture through the graduation research. As a result,the productwas completed on March 31 after the final graduation ceremony. The student engraved his name in the product and waswearing the satisfied face. We could confirm that the practical education as the purpose of this paper was achievedsufficiently.
2013-03-00