3301 インフュージョン法によるプレジャーボートハルの成形実験(OS5-1 安全,安心,低環境負荷の設計,OS5 安全・安心・防災・環境負荷低減,オーガナイズド・セッション)

概要

論文の詳細を見る
The infusion molding trial was conducted by using the pleasure boat mold of 9.5m in length and 4.2m in width. The base material in starboard side hull had the same stacking sequence as the laminated material used by an usual hand-lay-up method, and the material improved for the resin infusion molding process was used as for the portside. The resin has adjusted the viscosity for the infusion molding. As the result of infusion test, the resin impregnated enough at the case of the stacking sequence for hand-lay-up method. Moreover, the best arrangement of the resin inlet tube was obtained, and the improvement points on commercialization were clarified.
2008-12-09