Preliminary Experiments of Light-Pulse Waveform Synthesizer Implementing Optical Bistability Circuit

スポンサーリンク

概要

• 論文の詳細を見る

• This paper proposes an application of the optical Instability to an optical-waveform synthesizer. This device is featured with a sub-nanosecond speed achieved with employing both GaAs- and Si-optoelectronic switches as photo detector. A result of experiment for an optical pulse shaping is also given.

• 福山大学の論文

著者

• Kosaka Megumi

  Faculty Of Engineering Okayama University

• Kosaka Megumi

  Okayanma University

• KOGA Ryuji

  Okayama University

• Koga R

  Graduate School Of Natural Science And Technology Okayama University

• Sano H

  Japan Advanced Inst. Sci. And Technol. Ishikawa Jpn

• SANO Haruki

  Faculty of Engineering, Shinshu University

• Sano H

  Mitsubishi Electric Corp. Kamakura‐shi Jpn

• Sano Hiroya

  Department Of Electronic & Electrical Engineering Fukuyama University

• Sano Hiroya

  Department Of Electronic & Electric Engineering Fukuyama University

• Sano H

  Faculty Of Engineering Shinshu University

関連論文

• Low-Temperature Deposition of CuIn(S_xSe_)_2 Thin Films by Ionized Cluster Beam Technique
• Growth and Characterization of CuInS_2 Films grown by Rf Ion-Plating
• Modeling and Simulation of Via-Connected Power Bus Stacks in Multilayer PCBs(Printed Circuit Boards, 2004 International Symposium on Electromagnetic Compatibility)
• Efficient Calculation of Power Bus Impedance using a Fast Algorithm Together with a Segmentation Method
• A Simulation Method for EM Radiation from Power/Ground Plane of PCB by Using a Power Current Model, Vol.J86-B,No.2, pp.226-235
• Reduction of Q-factor of resonance in power/ground planes of multilayer PCBs by using resistive metal films
• Evaluation of EMI Reduction Effect of Guard Traces Based on Imbalance Difference Model
• Increase of Common-Mode Radiation due to Guard Trace Voltage and Determination of Effective Via-Location
• A Prediction Method of Common-Mode Excitation on a Printed Circuit Board Having a Signal Trace near the Ground Edge(Electromagnetic Compatibility (EMC))
• Power Current Model of LSI/IC Containing Equivalent Internal Impedance for EMI Analysis of Digital Circuits
• Preparation of Cuprous Oxide (Cu_2O) Thin Films by Reactive DC Magnetron Sputtering(Recent Progress in Oxide Thin Films by Sputtering)
• A Bidirectional Iteration Algorithm for Determining Lidar Ratios and its Use to Evaluate Boundary Values in the Lidar Inversion
• Common-Mode-Current Generation Caused by Difference of Unbalance of Transmission Lines on a Printed Circuit Board with Narrow Ground Pattern(Special Issue on Recent Progress in Electromagnetic Compatibility Technology)
• Linear Equivalent Circuit of a Digital Gate for Characterization of Malfunction Mechanism
• Prediction of Far-Field EMI Spectrum of Differential Mode Emission from a Digital PCB by Near-Field Measurement
• Special Issue on EMC Implications of Densely Mounted Electronic Devices
• Field Analysis of Pillbox Resonator with Radiation Loss Utilizing Finite-Element Beam Propagation Method Formulation
• Eigenmode Analysis of Whispering Gallery Modes of Pillbox-Type Optical Resonators Utilizing the FE-BPM Formulation
• Prediction of Peak Frequencies on Electromagnetic Emission from a Signal Line on a Printed Circuit Board
• Scintillation of far-infrared laser beam of wavelength in absorption region
• In Situ and Real-Time Measurement of Methane Concentration in Rice Paddy Field at Okayama University Using Tunable Diode Laser Absorption Spectrometry
• Adjoint Spectrum I: an Algorithm to Extract Target Spectra Under Spectral Interferences for Use in On-Line Spectrometry
• Power-Sum Estimation of Electromagnetic Noise Radiated from High-Speed CMOS Printed Circuit Boards
• BaTiO_3-Based Non-Reducible Low-Loss Dielectric Ceramics
• Suppression of Guard-Trace Resonance by Matched Termination for Reducing Common-Mode Radiation
• Calculation of Common-Mode Radiation from Single-Channel Differential Signaling System Using Imbalance Difference Model
• High Sensitivity Short-Path Monitoring of Trace Gases Employing PbSnTe Tunable Diode Laser
• Hard Magnetic MnAl and MnBi Ribbons Made from Molten State by Rapid Cooling
• LiTaO_3 Waveguide Optical Gate for Observation of Time-Domain Optical Pulse
• Fundamental Experiments of Dual Pulse Laser Excitation for On-line Analysis of Steel Refining Process
• A New Model for Impulse Noise Distribution Resulting from Digital Apparatus
• Power-Sum Estimation of Electromagnetic Noise Radiated from High-Speed CMOS Printed Circuit Boards
• A Tunable Diode Laser Gas-Density Spectrometry with the Coverage from Trace Species to Rich Fuel Transients
• Preliminary Experiments of Light-Pulse Waveform Synthesizer Implementing Optical Bistability Circuit
• Analytical Description of Tunable Diode Laser Derivative Spectrometry
• Characterization of cuInSe_2 thin Films by Photoluminescence Measurements
• Research on Automatic Measurement of Impulse Electromagnetic Noise (V) : Digital Circuit Model to Predict Spectra of Electromagnetic Radiation Noise
• Effect of Microstructure on Reliability of Ca(TiZr)O_3-Based Multilayer Ceramic Capacitors
• Research on Automatic Measurement of Impulse Magnetic Noise (VI) : Malfunction of Digital Circuit Caused by Electromagnetic Noise(B.Article,Special Edition for the 20th Anniversary of the University)

もっと見る 閉じる

スポンサーリンク