Chip Design of Structure Monitoring Sensor Driving IC for Telemetrics Applications(Session8A: Si Devices III)
スポンサーリンク
概要
- 論文の詳細を見る
This paper proposer a chip and implementation of optical fiber sensor IC for structure monitoring system. We studied and concluded the specifications required in the structure monitoring system which can drive and receive the signal The adopted topology was possible to implemented to make an IC. In order to monitor the signal generated from structure, the system is divided into a transmitter and receiver. In this applications because the band of the signal is lower than a few hundred kHz, it was necessary to use DC coupling interconnection between circuits, and designed to focus on gain and stability instead of the operating speed.
- 社団法人電子情報通信学会の論文
- 2008-07-02
著者
-
Burm Jinwook
Department of Electronic Engineering, Sogang University
-
Burm Jinwook
Department Of Electric Engineering Sogang University
-
Jung Bae-ki
Department Of Electric Engineering Sogang University
-
Lee Jun-gyu
Department Of Electric Engineering Sogang University
関連論文
- Piezoelectric material based passive RFID tags(Session 1A : Emerging Device Technology 1)
- Piezoelectric material based passive RFID tags(Session 1A : Emerging Device Technology 1)
- A 425MHz Narrow Channel Spacing Frequency Synthesizer(Session9A: Silicon Devices IV)
- A 425MHz Narrow Channel Spacing Frequency Synthesizer(Session9A: Silicon Devices IV)
- Chip Design of Structure Monitoring Sensor Driving IC for Telemetrics Applications(Session8A: Si Devices III)
- Chip Design of Structure Monitoring Sensor Driving IC for Telemetrics Applications(Session8A: Si Devices III)
- A 0.18μm CMOS 12Gb/s 10-PAM Serial Link Transmitter
- A Low-Power Switching Method with a Bootstrapping Circuit for High-Speed Transmitters
- 1.5-9.7-Gb/s Complete 4-PAM Serial Link Transceiver with a Wide Frequency Range CDR