Noncontact Measuring Method of Pitch(Nano/micro measurement and intelligent instrument)
スポンサーリンク
概要
- 論文の詳細を見る
The pitch of machine parts influences its quality and therefore the quality control of pitch by precise measurement is demanded strongly in industries. The measurement of pitch is, however, usually time-consuming process if touch probe is used. Noncontact measurement is also used but it has difficulty in working distance or stability of measurement. In this report, a new noncontact measuring method of pitch is proposed. The image of surface of moving object is taken consecutively and the degree of focusing is evaluated for each image. The pitch is measured by analyzing the whole wave form corresponding to the change of focusing value. The principle of measurement is proposed and the fundamental experiment for pitch measurement is carried out.
- 一般社団法人日本機械学会の論文
- 2005-10-18
著者
-
Kubo Aizoh
Department Of Mechanical Engineering And Science Kyoto University
-
Oda Yoshihiro
Department Of Mechanical Engineering And Science Kyoto University
-
KOMORI Masaharu
Department of mechanical engineering and science, Kyoto university
-
MATSUOKA Yukihiro
Department of mechanical engineering and science, Kyoto university
-
Matsuoka Yukihiro
Department Of Mechanical Engineering And Science Kyoto University
-
Komori Masaharu
Department Of Mechanical Engineering And Science Kyoto University
関連論文
- GDN-13 TRANSMISSION ERROR PREDICTION METHOD OF PLANETARY GEARS TAKING ACCOUNT OF ALIGNMENT ERROR(DYNAMICS AND NOISE PROBLEMS OF GEARS AND GEAR BOXES)
- New Optical System for Reducing the Interference Fringe Density in Laser Interferometric Measurement of Tooth Flank Form of a Gear
- GI-3 MEASUREMENT OF FORM DEVIATION OF GEAR TOOTH FLANK USING A PLATE AS REFERENCE SURFACE BY LASER INTERFEROMETER WITH AN ANGLE OF LARGE INCIDENCE(GEAR INSPECTION)
- GI-09 EVALUATION OF PITCH MEASURING INSTRUMENT USING MULTIBALL ARTIFACT(INSPECTION OF GEARS)
- GI-10 EVALUATION METHOD OF GEAR MEASURING INSTRUMENT USING V-GROOVE ARTIFACT(INSPECTION OF GEARS)
- GI-08 EVALUATION OF GEAR MEASURING INSTRUMENT USING MULTIPLE-TOOTH INVOLUTE HELICOID ARTIFACT(INSPECTION OF GEARS)
- Roll-Finishing of a Quenched Gear
- Profile and Longitudinal Modification of a Roll-Finishing Die-Wheel
- GSD-5 FACE GEAR DEVELOPMENT AND ENDURANCE TEST FOR AIRCRAFT APPLICATION(GEAR STRENGTH AND DURABILITY)
- A Method of Vibration Estimation of Gears with Unknown Gear Accuracy
- Estimation of Transmission Error of Cylindrical Involute Gears by Tooth Contact Pattern
- Equivalent Misalignment of Gears Due to Deformation of Shafts, Bearings and Gears : Model Proposal and Development of Calculation Program
- Noncontact Measuring Method of Pitch(Nano/micro measurement and intelligent instrument)
- Method of Preventing Cutting Edge Failure of Hob Due to Chip Crush
- Simultaneous Optimization of Tooth Flank Form of Involute Helical Gears in Terms of Both Vibration and Load Carrying Capacity
- GSD-4 FAILURE MODES DUE TO EDGE CONTACT OF CARBURIZED TOOTH FLANK(GEAR STRENGTH AND DURABILITY)
- Control Method for Output Speed during Velocity Ratio Change under High Rotational Speed Using an Uninterrupted Transmission System