GSD-4 FAILURE MODES DUE TO EDGE CONTACT OF CARBURIZED TOOTH FLANK(GEAR STRENGTH AND DURABILITY)
スポンサーリンク
概要
- 論文の詳細を見る
The endurance test of the gears designed for very high loading capacity showed some types of failures, that are very characteristic to such gears : Big influence of edge contact at tooth side and tip on the failure was observed. It is because relatively small amount of crowning and tip relief was given to lead form and profile form of those gears respectively in comparison with that of usual gears to make the load distribution over whole tooth Hank flat. Material condition and pitting cracks observed on the surface near side boundary of contacting area of tooth flank suggested that a cause of such failure is the repeated go and back contact-slipping between tooth side edge and mating tooth flank surface. The trochoidal interference appeared near tooth root of the test helical gears and plastic flow and white layer were found there. Chipping was observed at edges of tooth of smaller-face-width gear and micro cracks initiated from the chipping. Fatigue fracture proceeded from those cracks into the subsurface of gear tooth and led to tooth breakage. Most of those failures are not well recognized by gear designers until now and there is not yet any method to predict load carrying capacity of gears concerning such failure modes.
- 一般社団法人日本機械学会の論文
- 2001-11-15
著者
-
Ichihara Yoshio
Development Division Komatsu Ltd.
-
KOMORI Masaharu
Department of mechanical engineering and science, Kyoto university
-
Kubo Aizoh
Jsme Rc-156 Research Committee On Gear Technology:department Of Precision Engineering Kyoto Universi
-
TAKAHASHI Tomoyuki
JSME RC-156 Research Committee on Gear Technology
-
Komori Masaharu
Department Of Mechanical Engineering And Science Kyoto University
-
Komori Masaharu
Department Of Precision Engineering Kyoto University
-
Takahashi Tomoyuki
Jsme Rc-156 Research Committee On Gear Technology:development Division Komatsu Ltd.
関連論文
- GDN-13 TRANSMISSION ERROR PREDICTION METHOD OF PLANETARY GEARS TAKING ACCOUNT OF ALIGNMENT ERROR(DYNAMICS AND NOISE PROBLEMS OF GEARS AND GEAR BOXES)
- GI-09 EVALUATION OF PITCH MEASURING INSTRUMENT USING MULTIBALL ARTIFACT(INSPECTION OF GEARS)
- GI-10 EVALUATION METHOD OF GEAR MEASURING INSTRUMENT USING V-GROOVE ARTIFACT(INSPECTION OF GEARS)
- GI-08 EVALUATION OF GEAR MEASURING INSTRUMENT USING MULTIPLE-TOOTH INVOLUTE HELICOID ARTIFACT(INSPECTION OF GEARS)
- Noncontact Measuring Method of Pitch(Nano/micro measurement and intelligent instrument)
- Method of Preventing Cutting Edge Failure of Hob Due to Chip Crush
- Simultaneous Optimization of Tooth Flank Form of Involute Helical Gears in Terms of Both Vibration and Load Carrying Capacity
- GSD-4 FAILURE MODES DUE TO EDGE CONTACT OF CARBURIZED TOOTH FLANK(GEAR STRENGTH AND DURABILITY)
- Control Method for Output Speed during Velocity Ratio Change under High Rotational Speed Using an Uninterrupted Transmission System