Estimation of Transmission Error of Cylindrical Involute Gears by Tooth Contact Pattern
スポンサーリンク
概要
- 論文の詳細を見る
The correlation between the transmission error of gears and some factors which are usually considered to express characteristics of a tooth contact pattern, such as areal percentage and total length of simultaneous contact lines, is examined, but very poor correlation is found. A new method of estimating the transmission error from a tooth contact pattern is introduced. This is a method of supposing a triangular shape for the composite error on the actual contact line, which results in the ridge figure of the composite error surface as a function of the tooth contact pattern. The transmission error is derived as a function of this ridge figure. The results estimated by this method showed fairly good correlation with the actual transmission error, especially for a low transmitting load. Based on this method, an index value to estimate the amplitude of transmission error of a gear pair by the observation of tooth contact pattern is also introduced.
- 一般社団法人日本機械学会の論文
- 1991-06-15
著者
-
KUBO Aizoh
Department of Precision Engineering, Graduate School of Engineering, Kyoto University
-
Kubo Aizoh
Department Of Mechanical Engineering And Science Kyoto University
-
Kubo A
Department Of Precision Mechanics Faculty Of Engineering Kyoto University
-
Kuboki Takashi
Department Of Precision Mechanics Faculty Of Engineering Kyoto University
-
NONAKA Teysuya
Department of Precision Mechanics, Faculty of Engineering, Kyoto University
-
Nonaka T
Kyoto Univ. Kyoto Jpn
-
Kuboki Takashi
Department Of Mechanical Engineering & Intelligent Systems University Of Electro-communications
関連論文
- New Optical System for Reducing the Interference Fringe Density in Laser Interferometric Measurement of Tooth Flank Form of a Gear
- GI-3 MEASUREMENT OF FORM DEVIATION OF GEAR TOOTH FLANK USING A PLATE AS REFERENCE SURFACE BY LASER INTERFEROMETER WITH AN ANGLE OF LARGE INCIDENCE(GEAR INSPECTION)
- GI-10 EVALUATION METHOD OF GEAR MEASURING INSTRUMENT USING V-GROOVE ARTIFACT(INSPECTION OF GEARS)
- GI-08 EVALUATION OF GEAR MEASURING INSTRUMENT USING MULTIPLE-TOOTH INVOLUTE HELICOID ARTIFACT(INSPECTION OF GEARS)
- Roll-Finishing of a Quenched Gear
- Profile and Longitudinal Modification of a Roll-Finishing Die-Wheel
- GSD-5 FACE GEAR DEVELOPMENT AND ENDURANCE TEST FOR AIRCRAFT APPLICATION(GEAR STRENGTH AND DURABILITY)
- A Method of Vibration Estimation of Gears with Unknown Gear Accuracy
- A Computer Based Approach for Evaluation of Operating Performances of Bevel and Hypoid Gears
- The effect of oral contrast on large bowel activity in FDG-PET/CT
- FDG-PET/CT findings of sarcomatous transformation in neurofibromatosis : a case report
- Estimation of Transmission Error of Cylindrical Involute Gears by Tooth Contact Pattern
- Equivalent Misalignment of Gears Due to Deformation of Shafts, Bearings and Gears : Model Proposal and Development of Calculation Program
- Noncontact Measuring Method of Pitch(Nano/micro measurement and intelligent instrument)
- Method of Preventing Cutting Edge Failure of Hob Due to Chip Crush
- Simultaneous Optimization of Tooth Flank Form of Involute Helical Gears in Terms of Both Vibration and Load Carrying Capacity
- -1171-DISTRIBUTION OF THE ARTIFICIAL DEFECTS OF THE EXERCISE THALLIUM MYOCARDIAL PERFUSION SPECT : THE 54th ANNUAL SCIENTIFIC MEETING OF THE JAPANESE CIRCULATION SOCIETY
- Development of a Tube-Spinning Machine for Thin Tubes with a Large Diameter