A Tooth Surface Finishing Method with a New Tool of a Vitrified Cubic Boron Nitride Wheel for Involute Internal Spline
スポンサーリンク
概要
- 論文の詳細を見る
For highly accurate and highly efficient tooth surface finishing, a vitrified cubic boron nitride (CBN) wheel or an electro-deposited CBN wheel exhibits superior performance. Honing by an involute spline tooth meshing is effective due to the generating motion. However, a lack of wheel rigidity and an inadequate feed motion of the wheel tend to reduce the finishing performance. As a result, it is difficult to keep the tooth surface smooth. In this study, the finishing with a vitrified CBN wheel is carried out using a new honing tool. The finishing performance is compared with that obtained using an electro-deposited wheel, and the finishing is carried out by braking an internal spline axis. The influence of different feed methods is investigated on the roughness of the finished tooth surface. The finishing using a vitrified CBN wheel and braking an internal spline axis shows superior performance.
- 一般社団法人日本機械学会の論文
- 2001-06-15
著者
-
Ariura Yasutsune
Department of Mechanical Engineering, Graduate School of Engineering,Kyushu University
-
Mizuno Sadao
Aisin Seiki Co. Ltd.
-
Mizuno Sadao
Aisin Seiki Co. Ltd
-
MORITA Tetuya
Aisin Seiki Co. Ltd.
-
Ariura Yasutsune
Department Of Mechanical Engineering Kyushu Univercity
-
Ariura Yasutsune
Department Of Intelligent Machinery And Systems Kyushu University
関連論文
- GM-06 TRANSIENT PHENOMENON OF CHIP GENERATION AND ITS MOVEMENT IN HOBBING : JAMMING OF CHIP FORMED IN GENERATING ON FINISHED SURFACE IN FLYTOOL SIMULATION TESTS(MANUFACTURING OF GEARS)
- GM-4 TRANSIENT PHENOMENON OF CHIP GENERATIONS AND MOVEMENTS IN HOBBING(GEAR MANUFACTURING)
- GSD-21 A FUNDAMENTAL STUDY ON THE SURFACE DURABILITY OF AUSTEMPERED DUCTILE IRON (ADI) GEARS IN LONG LIFE REGION(GEAR STRENGTH AND DURABILITY, INCLUDING GEAR MATERIALS AND HEAT TREATMENT TECHNIQUES)
- A Tooth Surface Finishing Method with a New Tool of a Vitrified Cubic Boron Nitride Wheel for Involute Internal Spline
- GM-7 A TOOTH SURFACE FINISHING METHOD WITH A NEW TOOL OF A VITRIFIED CUBIC BORON NITRIDE WHEEL FOR INVOLUTE INTERNAL SPLINE(GEAR MANUFACTURING)
- A New Tooth Finishing Method with cBN Wheel for Involute Internal Spline - Improvement of Tooth Accuracy with Slant Traverse Method -
- GI-1 TRANSMISSION ERROR ANALYSIS WITH ECCENTRICITY OF INVOLUTE CYLINDRICAL GEARS(GEAR INSPECTION)