GM-4 TRANSIENT PHENOMENON OF CHIP GENERATIONS AND MOVEMENTS IN HOBBING(GEAR MANUFACTURING)

スポンサーリンク

概要

• 論文の詳細を見る

• The chip behavior that means the sticking at the cutting edge, movements after cut, flying directions and so on influences on tool wear and surface finish quality. The transient phenomenon of chip generations and behavior in milling and hobbing are investigated by using high speed video camera. In many cases, the chip flies rotationally after that the top end of chip touches with the work surface. Observation of chip generations in millings clarifies that the chip flow on the cutting edge changes at the corner due to the interference of chips from both sides cutting edges. Moreover, the chip behavior in gear hobbing of finish process and in hobbing of a special blank workpiece with one tooth space is investigated. New visual findings such as the chip interference on rake surface and the way of contact with the work surface can be obtained.

• 2001-11-15

著者

• Umezaki Yoji

  Department Of Intelligent Machinery And Systems Kyushu University

• Ariura Yasutsune

  Department Of Intelligent Machinery And Systems Kyushu University

• MATSUMOTO Hiroki

  Fuji Heavy Industries, LTD

• YOSHIMURA Keisuke

  Department of Intelligent Machinery and Systems, Kyushu University

• KIMURA Daijiro

  Department of Intelligent Machinery and Systems, Kyushu University

• Matsumoto Hiroki

  Fuji Heavy Industries Ltd

• Kimura Daijiro

  Department Of Intelligent Machinery And Systems Kyushu University

• Yoshimura Keisuke

  Department Of Intelligent Machinery And Systems Kyushu University

関連論文

• GM-06 TRANSIENT PHENOMENON OF CHIP GENERATION AND ITS MOVEMENT IN HOBBING : JAMMING OF CHIP FORMED IN GENERATING ON FINISHED SURFACE IN FLYTOOL SIMULATION TESTS(MANUFACTURING OF GEARS)
• GM-4 TRANSIENT PHENOMENON OF CHIP GENERATIONS AND MOVEMENTS IN HOBBING(GEAR MANUFACTURING)
• GSD-21 A FUNDAMENTAL STUDY ON THE SURFACE DURABILITY OF AUSTEMPERED DUCTILE IRON (ADI) GEARS IN LONG LIFE REGION(GEAR STRENGTH AND DURABILITY, INCLUDING GEAR MATERIALS AND HEAT TREATMENT TECHNIQUES)
• A Tooth Surface Finishing Method with a New Tool of a Vitrified Cubic Boron Nitride Wheel for Involute Internal Spline
• GM-7 A TOOTH SURFACE FINISHING METHOD WITH A NEW TOOL OF A VITRIFIED CUBIC BORON NITRIDE WHEEL FOR INVOLUTE INTERNAL SPLINE(GEAR MANUFACTURING)
• GDN-01 INFLUENCE OF GEAR ECCENTRICITY ON SIDEBANDS OF MESH FREQUENCY : DERIVATION AND DETECTION OF AMPLITUDE MODULATION BY TRANSMISSION ERROR MEASUREMENT(DYNAMICS AND NOISE PROBLEMS OF GEARS AND GEAR BOXES)
• GI-1 TRANSMISSION ERROR ANALYSIS WITH ECCENTRICITY OF INVOLUTE CYLINDRICAL GEARS(GEAR INSPECTION)

スポンサーリンク