X 線回折法による溶接組立材の残留応力測定 (第 2 報)

概要

論文の詳細を見る
In order to evaluate the applicability of two kinds of techniques of the X-ray stress analysis, namely, the standard sin^2ψ method and the newly developed φ-sin^2ψ method, bending tests have been performed. The test results have proved that the values of the stresses measured by means of the mechanical devices and of those measured by the two kinds of the X-ray techniques coincide each other. Then, these two methods have been applied to measure the surface residual stresses of the box-typed, welded steel columns and the following conclusions have been drawn. 1. The principal stress of the surface residural stresses is, in most cases, oriented to the rolled directions at the center of the steel plates, and it tends to rotate in the neighborhood of the heat affected zones. 2. Tensile residual stresses of a large magnitude have been observed in the direction parallel to the beads of the weld, and the moderate compressive residual stresses can be detected in the direction normal to the beads.
社団法人日本建築学会の論文
1982-11-30