Controllable Pressure Sensor Based on a Side-Polished Single Mode Fiber and Polymer Planar Waveguide Coupler

スポンサーリンク

概要

• 論文の詳細を見る

• We report pressure sensor based on a single mode side-polished fiber and polymer planar waveguide. It is found that the resonance wavelength shift occurs due to refractive index variation of polymers by pressure and its sensitivity depends on waveguiding polymers. The symmetric structure of planar waveguide was adopted in order to remove the polarization dependence which is inevitable with the side polished fiber. THB-30 and AZ1512 are used as planar waveguide polymers and the resonance wavelength shifts by applied pressure were shown 0.16nm/bar, 0.033nm/bar respectively.

• 社団法人電子情報通信学会の論文
• 2001-06-29

著者

• Kang S‐w

  Kyungpook National Univ. Daegu Kor

• Kim S‐w

  Department Of Electronic Science And Engineering Kyoto University

• Kim Sang-woo

  Department Of Sensor Engineering Kyungpook National University

• Yoon Jong-kuk

  Department Of Information And Telecommunication Sung-duk College

• Kim Eung-su

  Division Of Electronic And Computer Engineering Pusan University Of Foreign Studies

• Jung Woong-Gyu

  Department of Sensor Engineering, Kyungpook National University

• Kang Shin-Won

  School of Electronic and Electrical Engineering, Kyungpook National University

• Lee Deung-Ha

  School of Electronic and Electrical Engineering, Kyungpook National University

• Kim Sang-woo

  Department Of Electronic Science And Engineering Kyoto University

• Jung Woong-gyu

  Department Of Sensor Engineering Kyungpook National University

• Kang Shin-won

  School Of Electrical Engineering And Computer Science Kyungpook National University

• Lee Deung-ha

  School Of Electronic And Electrical Engineering Kyungpook National University

• Kim Sang-Woo

  Department of Architectural Engineering, Kongju National University

関連論文

• Estimation of Direct Radiative Forcing of Asian Dust Aerosols with Sun/Sky Radiometer and Lidar Measurements at Gosan, Korea
• Controllable Pressure Sensor Based on a Side-Polished Single Mode Fiber and Polymer Planar Waveguide Coupler
• Controllable Pressure Sensor Based on a Side-Polished Single Mode Fiber and Polymer Planar Waveguide Coupler
• Focused Ion Beam Patterning for Fabrication of Periodical Two-Dimensional Zinc Oxide Nanodot Arrays
• Self-Tailored One-Dimensional ZnO Nanodot Arrays Formed by Metalorganic Chemical Vapor Deposition
• Self-Assembled Three-Dimensional ZnO Nanosize Islands on Si Substrates with SiO_2 Intermediate Layer by Metalorganic Chemical Vapor Deposition : Semiconductors
• A Proposal of Effective Compensation Method for IR Lamp Deterioration in NDIR Type Capnograph Systems(Special Section on Papers Selected from ITC-CSCC 2002)
• High Speed LAPS System for pH Image Using Line Scanning with a Chopping Wheel
• High-Sensitivity Temperature Sensor Using Thermo-Optic Polymer Waveguide Overlays on Side-Polished Single Mode Fiber
• High-Sensitivity Temperature Sensor Using Thermo-Optic Polymer Waveguide Overlays on Side-Polished Single Mode Fiber
• Substrate Heated Spray-Deposition Method for High Efficient Organic Solar Cell: Morphology Inspection
• Enhancement of Active Layer Characteristics with Solvent Spray Annealing Treatment for Organic Solar Cell
• Transfer Printing Method to Obtain Polarized Light Emission in Organic Light-Emitting Device
• Self-Tailored One-Dimensional ZnO Nanodot Arrays Formed by Metalorganic Chemical Vapor Deposition
• Focused Ion Beam Patterning for Fabrication of Periodical Two-Dimensional Zinc Oxide Nanodot Arrays
• Enhancement of Operating Lifetime and Performance on Polymer Light Emitting Diode by Mg--Zn--F Passivation
• Applicability of Ground Granulated Blast-Furnace Slag for Precast Concrete Beams Subjected to Bending Moment

もっと見る 閉じる

スポンサーリンク