Research on CBN Finishing Hob : Turning and Fly Tool Cutting Tests

スポンサーリンク

概要

• 論文の詳細を見る

• The development of CBN finishing hobs able to finish hardened gears efficiently and accurately is the objective of this research. To study the possibility of a CBN finishing hob, intermittent turning tests and fly tool cutting tests similar to hobbing were carried out. The optimum form and size for the chamfer land of the cutting edge were determined. The influences of cutting speed and workpiece hardness on the flank wear and the roughness of the finished surface were clarified. It was also shown that dead metal occurs on the chamfered cutting edge and roughens the cutting surface. Without dead metal, the roughness of the cutting surface corresponds to that of the flank face.

• 一般社団法人日本機械学会の論文
• 1988-09-15

著者

• Hidaka Kazunori

  Sasebo College Of Technology

• NAKAE Masahiko

  Sasebo Technical College

• Nakae Masahiko

  Sasebo College Of Technology

関連論文

• STUDIES ON THE WEAR OF HOB : Influence of Face Roughness of Tooth upon Tool Wear
• RESEARCH ON THE TAPERED HOBS
• Graphic Analysis of Hobbing in Unfinished Space
• Research on CBN Finishing Hob : Turning and Fly Tool Cutting Tests

スポンサーリンク