E111 Characteristics of Heat Transfer and Critical Heat Flux of Flow Boiling in a Vertical Tube with a Wire Coil(Critical heat flux)
スポンサーリンク
概要
- 論文の詳細を見る
The boiling heat transfer and the critical heat flux characteristics were experimentally investigated in a SUS316 vertical tube with a Teflon-coated wire coil of various wire diameters and pitches by using HCFC-123 as the working fluid. The tube wall was uniformly heated by a DC current. The experimental conditions were a mass flux G=200-400 kg/m^2s and a thermal equilibrium quality at the exit of the tube x_<cq>=0.1-0.8. The values of the boiling heat transfer coefficients in the tube with a wire coil were almost equal to those in a smooth tube in the nucleate boiling region, but a little enhancement of the heat transfer was observed in the forced convective evaporation region. The critical heat fluxes in the tube with a wire coil were larger than those in the smooth tube in the higher quality region.
- 一般社団法人日本機械学会の論文
- 2000-10-01
著者
-
Asano Hitoshi
Department Of Mechanical Engineering Kobe University
-
TAKENAKA Nobuyuki
Dept.of Mechanical Engineering, Kobe University
-
TAKESHIMA Keishi
Dept. of Mechanical Engineering, Kochi National College of Technology
-
FUJII Terushige
Dept. of Mechanical Engineering, Kobe University
-
ASANO Hitoshi
Dept. of Mechanical Engineering, Kobe University
-
KONDO Takamitsu
Dept. of Mechanical Engineering, Kobe University
-
Kondo Takamitsu
Dept. Of Mechanical Engineering Kobe University
-
Asano Hitoshi
Dept. Of Mech. Eng. Kobe University
-
Takeshima Keishi
Dept. Of Mechanical Engineering Kochi National College Of Technology
-
TAKENAKA Nobuyuki
Department of Mechanical Engineering, Kobe University
-
ASANO Hitoshi
Dept. Mechanical Engineering, Graduate School of Engineering, Kobe University
関連論文
- Visualization and void fraction measurement of gas-liquid two-phase flow in a commercial plate heat exchanger by thermal neutron radiography
- Flow Pattern and Heat Transfer in Tube Banks of a Simulated Fluidized-Bed Heat Exchanger
- A105 Development of the New Heat Supply Unit for the Neighboring Communities Co-generation System
- Visualization and void fraction measurement of gas-liquid two-phase flow in plate heat exchanger
- B213 VOID FRACTION DISTRIBUTIONS OF AIR-WATER TWO-PHASE FLOW IN A ROD BUNDLE MEASURED BY NEUTRON RADIOGRAPHY(Nuclear power-3)
- G106 FLOW PATTERN AND VOID FRACTION DISTRIBUTION OF GAS-LIQUID TWO-PHASE FLOW IN A PLATE HEAT EXCHANGER MEASURED BY NEUTRON RADIOGRAPHY(Heat pipe fundamental and application)
- Development of Heat Supply Unit Using Phase Change Materials for the Neighboring Communities Co-Generation System
- Transient Characteristics of Vapor Flow with Evaporating and Condensing in a Closed Vessel
- A309 THE PHASE SEPARATION CHARACTERISTICS OF A GAS-LIQUID TWO-PHASE FLOW IN AN IMPACTING Y-JUNCTION. : Application to microgravity condition(Phase separation)
- E111 Characteristics of Heat Transfer and Critical Heat Flux of Flow Boiling in a Vertical Tube with a Wire Coil(Critical heat flux)
- D115 VELOCITY AND VOID FRACTION MEASUREMENT IN MOLTEN LEAD-BISMUTH TWO-PHASE FLOW BY NEUTRON RADIOGRAPHY(Measurement by radiation/absorption)
- Image processing methods to obtain symmetrical distribution from projection image
- Visualization of the hygroscopic water distribution in an adsorbent bed by neutron radiography
- Visualization and void fraction distribution of downward gas-liquid two-phase flow in a plate heat exchanger by neutron radiography
- A104 SIMULATION AND OPTIMIZATION OF DISTRICTED ENERGY SUPPLY SYSTEM BASED ON EXERGY
- G314 AN EXERGY ANALYSIS OF THE LiBr-WATER TRIPLE-EFFECT ABSORPTION-TYPE REFRIGERATOR(Absorption heat pump)
- TED-AJ03-191 MICROGRAVITY TWO-PHASE FLOW CHARATERISTICS IN ADIABATIC PIPES
- TED-AJ03-180 A Study of High Performance Gas-Liquid Phase Separator by Utilizing Y-junction under Micro-gravity Condition
- A Study of the Flow Characteristics in Air-Water Two-Phase Flow under Microgravity : Results of Flight Experiments
- C314 A Study of Renewable Energy Hydrogen-Fired Power Generation Plants
- A102 AN IMPROVEMENT OF PERFORMANCE CHARACTERISTICS IN MUNICIPAL SOLID WASTE-BURNT POWER GENERATION(Nuclear power-1/combustion)
- Flow Injection On-line Column Separation for the Determination of Zinc in Steel by Atomic Absorption Spectrometry
- E110 DYNAMIC SIMULATION OF NEW CENTRAL HOT WATER SUPPLY SYSTEM FOR RESIDENTIAL BUILDING(Distributed Energy System-2)
- F107 DEVELOPMENT OF COMPACT LATENT HEAT RECOVERY HEAT EXCHANGER FOR GAS WATER HEATER IN HOUSEHOLD USE(Heat Exchanger)
- Preface