TED-AJ03-180 A Study of High Performance Gas-Liquid Phase Separator by Utilizing Y-junction under Micro-gravity Condition
スポンサーリンク
概要
- 論文の詳細を見る
Gas and liquid phases are easily separated owing to buoyancy on the ground. However, in space (i.e. under micro-gravity condition), the method cannot be adopted. In this study, a method of a Y-junction by using the difference of inertia force between gas and liquid phases is proposed for a first-step and rough separation. Experiments of phase separation in a horizontally placed impacting Y-junction were carried out under both normal and micro-gravity conditions. Phase separations in Y-junction for two-component and one-component two-phase flow were also examined. As a result, it was shown that the liquid could be extracted effectively from the two-phase flow by using a Y-junction under micro-gravity. The effect of inlet flow pattern of gas-liquid flow on phase separation performance was discussed.
- 一般社団法人日本機械学会の論文
著者
-
Fujii Terushige
Department Mechanical Of Engineering Kobe University
-
Asano Hitoshi
Department Of Mechanical Engineering Kobe University
-
Asano H
Department Of Mechanical Engineering Kobe University
-
SUGIMOTO Katsumi
Department of Mechanical Engineering, Kobe University
-
Shuang Ye
Department of Mechanical Engineering, Kobe University
-
Shuang Ye
Department Of Mechanical Engineering Kobe University
-
Asano Hitoshi
Dept. Of Mech. Eng. Kobe University
-
Asano Hitoshi
Faculty Of Engineering Kobe University
-
Asano Hitoshi
Department Of Applied Chemistry Faculty Of Engineering Gunma University
-
Sugimoto Katsumi
Faculty Of Engineering Kobe University
-
Sugimoto Katsumi
Department Of Mechanical Engineering Kobe University
関連論文
- Visualization and void fraction measurement of gas-liquid two-phase flow in a commercial plate heat exchanger by thermal neutron radiography
- Visualization and Measurement of Dynamic Water Behavior in Polymer Electrolyte Fuel Cell by Neutron Radiography
- Flow Characteristics of Gas-Liquid Two-Phase Annular Flow under Microgravity : Experimental Results Utilizing a Drop Tower
- The Behavior of an Immiscible Equal-Density Liquid Two-Phase Flow in a Horizontal Tube
- E113 BURN-OUT PHENOMENA OF A LIQUID NITROGEN FORCED CONVECTIVE FLOW IN A TUBE HEATED IN COSINE-DISTRIBUTION(Critical heat flux)
- Performance Characteristics of Hero's Turbine Using Hot Water as a Working Fluid
- A105 Development of the New Heat Supply Unit for the Neighboring Communities Co-generation System
- Performance Characteristics of Divergent-Convergent Nozzles for Subcooled Hot Water
- Visualization and void fraction measurement of gas-liquid two-phase flow in plate heat exchanger
- B213 VOID FRACTION DISTRIBUTIONS OF AIR-WATER TWO-PHASE FLOW IN A ROD BUNDLE MEASURED BY NEUTRON RADIOGRAPHY(Nuclear power-3)
- G106 FLOW PATTERN AND VOID FRACTION DISTRIBUTION OF GAS-LIQUID TWO-PHASE FLOW IN A PLATE HEAT EXCHANGER MEASURED BY NEUTRON RADIOGRAPHY(Heat pipe fundamental and application)
- Development of Heat Supply Unit Using Phase Change Materials for the Neighboring Communities Co-Generation System
- Transient Characteristics of Vapor Flow with Evaporating and Condensing in a Closed Vessel
- A study of Water Hammer Phenomena in a One-Component Two-Phase Bubbly Flow
- A309 THE PHASE SEPARATION CHARACTERISTICS OF A GAS-LIQUID TWO-PHASE FLOW IN AN IMPACTING Y-JUNCTION. : Application to microgravity condition(Phase separation)
- E111 Characteristics of Heat Transfer and Critical Heat Flux of Flow Boiling in a Vertical Tube with a Wire Coil(Critical heat flux)
- D115 VELOCITY AND VOID FRACTION MEASUREMENT IN MOLTEN LEAD-BISMUTH TWO-PHASE FLOW BY NEUTRON RADIOGRAPHY(Measurement by radiation/absorption)
- Image processing methods to obtain symmetrical distribution from projection image
- Visualization of the hygroscopic water distribution in an adsorbent bed by neutron radiography
- Visualization and void fraction distribution of downward gas-liquid two-phase flow in a plate heat exchanger by neutron radiography
- A104 SIMULATION AND OPTIMIZATION OF DISTRICTED ENERGY SUPPLY SYSTEM BASED ON EXERGY
- G314 AN EXERGY ANALYSIS OF THE LiBr-WATER TRIPLE-EFFECT ABSORPTION-TYPE REFRIGERATOR(Absorption heat pump)
- TED-AJ03-191 MICROGRAVITY TWO-PHASE FLOW CHARATERISTICS IN ADIABATIC PIPES
- TED-AJ03-180 A Study of High Performance Gas-Liquid Phase Separator by Utilizing Y-junction under Micro-gravity Condition
- A Study of the Flow Characteristics in Air-Water Two-Phase Flow under Microgravity : Results of Flight Experiments
- C314 A Study of Renewable Energy Hydrogen-Fired Power Generation Plants
- TED-AJ03-169 A Clean Environment Gas Turbine Cogeneration plant
- A102 AN IMPROVEMENT OF PERFORMANCE CHARACTERISTICS IN MUNICIPAL SOLID WASTE-BURNT POWER GENERATION(Nuclear power-1/combustion)
- Flow Injection On-line Column Separation for the Determination of Zinc in Steel by Atomic Absorption Spectrometry
- E110 DYNAMIC SIMULATION OF NEW CENTRAL HOT WATER SUPPLY SYSTEM FOR RESIDENTIAL BUILDING(Distributed Energy System-2)
- F107 DEVELOPMENT OF COMPACT LATENT HEAT RECOVERY HEAT EXCHANGER FOR GAS WATER HEATER IN HOUSEHOLD USE(Heat Exchanger)
- Study on the Effect of a Cogeneration System Capacity on its CO2 Emissions
- Visualization and Measurement of Hygroscopic Water Distribution in a Unit Cell of Silica-Gel Adsorber by Neutron Radiography