蒸発および燃焼中のCWM液滴の表面温度測定

概要

論文の詳細を見る
A single CWM droplet was suspended in a hot air stream by a fine R-type thermocouple. The surface temperature of this evaporating and burning droplet was measured by a radiation thermometer. The emissivity of the CWM droplet surface was kept at around 0.98 until the char combustion of the droplet proceeded to its middle stage. In the later stage of the char combustion, the emissivity decreased gradually to 0.82. Several degrees of temperature difference between the center and the surface of the droplet remained at the dry-up time, even when the diameter of the droplet was reduced to 2mm. The surface temperature at the start of char combustion was 700K when the droplet was exposed in surroundings of less than 900K. However, the surface temperature at the start increased from 700K in surroundings where it's temperature exceeded 900K. When the surroundings were 650K, the surface temperature at the char combustion start was 700K and higher than the surroundings, and the center temperature of the droplet was higher than that of the surface, which suggested that slow exothermic reactions in the droplet were already initiated before the char combustion started.
一般社団法人日本機械学会の論文
1991-11-25