環状切欠丸棒の最小断面の塑性ひずみ分布

概要

論文の詳細を見る
Plastic strain distributions obtained from the hardness number distribution at the net section have been compared with those calculated using the finite element method. Notched bars with a U-shaped circumferential notch were made of austenitic stainless steel (SUS), Ni-Cr-Mo steel (SNCM)and low-carbon steel (S20C). In the deformation range up to the maximum tensile load P_<max>, the strain distribution obtained using the two methods agreed well for all notch radii and materials employed. In the deformation range beyond P_<max> of netched bars of SUS, the two strain distributions agreed well for high notch sharpness, while for low notch sharpness, the difference between the two strain distributions increased with increasing deformation and with initial notch radius. For SNCM, the two strain distributions agreed well beyond P_<max>. Approximately the same strain distribution was produced prior to P_<max>, in spite of the distinct difference in mechanical properties and notch strength ratio.
一般社団法人日本機械学会の論文
1994-02-25