On Surface Finish Produced by Ceramic Tools
スポンサーリンク
概要
- 論文の詳細を見る
This investigation deals with the roughness and property of surface produced by ceramic tools in comparison with those produced by carbide tools. At first, we observed experimentally the effect of cutting conditions, tool geometries and flank wear on tools on the roughness of surfaces machined by ceramic and carbide tools. And the utililzation of the Surface Quality Meter which measures electrical contact resistance between graphite and machined surface, has revealed information concerning the effect of oxide layer on the lustre of machined surface. It is concluded from the results in this paper that in general the surface finish produced by ceramic tools is better than that produced by carbide tools.
- 一般社団法人日本機械学会の論文
著者
-
OKUSHIMA Keiji
Faculty of Engineering, Kyoto University
-
Okushima Keiji
Faculty Of Engineering Kyoto University
-
FUJII Yoshiya
Faculty of Engineering, Kyoto University
-
Fujii Yoshiya
Faculty Of Engineering Kyoto University
-
Okushima K.
Faculty of Engineering, Kyoto University
関連論文
- An Analysis of the Mechanism of Discontinuous Chip Formation
- Plastic Flow of Chip in Steel Cutting
- Action of Gaseous Environment in Metal Cutting : Surface Roughness and Tool Forces When Machining with Oxygen Jet
- A Fundamental Study of Super-High Speed Machining
- Physical Properties of Ceramic Tool Materials : (Especially on the Adhesion of Ceramics)
- On Surface Finish Produced by Ceramic Tools
- Machinability of Metals : Chip Formation of Leaded Steels
- On Analysis of Orthogonal Cutting Mechanism with a Pb-Sn Alloy
- On Analysis of Fluctuations of Flank-Wear Tool Life
- On the Behaviour of Chip in Steel Cutting : Part 2,In the Case of Parallel Type Chip Breaker
- A Study of Machinability of Metals : Effect of Microstructure of Materials on Cutting Mechanism
- A Contribution to Determination of Tool Change Interval
- On Ceramic Cutting Tools : In the Case of Machining Carbon Steel
- Observation of Cutting Mechanism of Cast Iron