On the Behaviour of Chip in Steel Cutting : Part 2,In the Case of Parallel Type Chip Breaker

スポンサーリンク

概要

• 論文の詳細を見る

• This paper describes the behaviour of the chip in steel cutting by the lathe tool with the parallel type chip breaker, which is the most fundamental type of the chip breaker. The first half describes about the curling radius of the chip bent by the chip breaker. We present here a new equation about the curling radius. The latter half describes about chip breaking by the chip breaker. Using the above equation of the curling radius, we succeeded in an equational representation of the conditions in which the chip is properly broken. On the basis of this equational representation, a chart was drawn up for the design of the chip breaker.

• 一般社団法人日本機械学会の論文

著者

• Okushima Keiji

  Faculty Of Engineering Kyoto University

• Hoshi Tetsutaro

  Faculty Of Engineering Kyoto University

• FUJINAWA Takashi

  Kishaseizo Ltd.

関連論文

• An Analysis of the Mechanism of Discontinuous Chip Formation
• Plastic Flow of Chip in Steel Cutting
• Action of Gaseous Environment in Metal Cutting : Surface Roughness and Tool Forces When Machining with Oxygen Jet
• A Fundamental Study of Super-High Speed Machining
• Physical Properties of Ceramic Tool Materials : (Especially on the Adhesion of Ceramics)
• On Surface Finish Produced by Ceramic Tools
• Machinability of Metals : Chip Formation of Leaded Steels
• On the Behaviour of Chip in Steel Cutting : Part 2,In the Case of Parallel Type Chip Breaker
• A Study of Machinability of Metals : Effect of Microstructure of Materials on Cutting Mechanism
• A Contribution to Determination of Tool Change Interval
• On Ceramic Cutting Tools : In the Case of Machining Carbon Steel
• Observation of Cutting Mechanism of Cast Iron

もっと見る 閉じる

スポンサーリンク