On Ceramic Cutting Tools : In the Case of Machining Carbon Steel
スポンサーリンク
概要
- 論文の詳細を見る
This paper describes the experimental results about the relation between the physical properties and the life of ceramic tools, the cutting performance of trial products in comparison with a carbide tool of a steel cutting grade, and optimum tool geometry and cutting condition of ceramic tool, at machining 0.4% carbon steel. The results are as follows : (1) The cutting performance of ceramics is greatly affected by the physical properties of ceramics. (2) The type of failure of ceramic tool is essentially the same as that of carbide tool. (3) It is necessary to choose proper tool geometery and cutting condition of ceramic tool for the increase of tool life.
- 一般社団法人日本機械学会の論文
著者
-
Okushima Keiji
Faculty Of Engineering Kyoto University
-
Fujii Yoshiya
Faculty Of Engineering Kyoto University
-
Fujii Yoshiya
Faculty Of Engineering Kyoto University.
関連論文
- An Analysis of the Mechanism of Discontinuous Chip Formation
- Plastic Flow of Chip in Steel Cutting
- Action of Gaseous Environment in Metal Cutting : Surface Roughness and Tool Forces When Machining with Oxygen Jet
- A Fundamental Study of Super-High Speed Machining
- Physical Properties of Ceramic Tool Materials : (Especially on the Adhesion of Ceramics)
- On Surface Finish Produced by Ceramic Tools
- Machinability of Metals : Chip Formation of Leaded Steels
- On Analysis of Orthogonal Cutting Mechanism with a Pb-Sn Alloy
- On Analysis of Fluctuations of Flank-Wear Tool Life
- On the Behaviour of Chip in Steel Cutting : Part 2,In the Case of Parallel Type Chip Breaker
- A Study of Machinability of Metals : Effect of Microstructure of Materials on Cutting Mechanism
- A Contribution to Determination of Tool Change Interval
- On Ceramic Cutting Tools : In the Case of Machining Carbon Steel
- Observation of Cutting Mechanism of Cast Iron