Stresses in a Circular Cylindrical Shell Having Two Circular Cutouts
スポンサーリンク
概要
- 論文の詳細を見る
Stress analysis for a circular cylindrical shell having two circular cutouts of equal size is worked out. The following four cases are treated. A circular cylindrical shell having two circular cutouts of equal size (a) in a longitudinal direction under uniform tension, (b) in a circumferential direction under uniform tension, (c) in a longitudinal direction under internal pressure and (d) in a circumferential direction under internal pressure. The method of Green's general biharmonic analysis is extended to this problem and the boundary conditions along the edge of cutouts are satisfied by the point-matching method. Numerical solutions are obtained for three kinds of diameter of circular cutout and four kinds of center-distance of the cutouts. Especially, in the cases of (a) and (b), the results are compared with those of the flat plate.
- 一般社団法人日本機械学会の論文
著者
-
Kishida Michiya
Faculty Of Engineering Hokkaido University
-
HANZAWA Hiroshi
Faculty of Engineering, Hokkaido University
-
MURAI Masamitsu
Faculty of Engineering. Hokkaido University.
-
TAKASHINA Kenzo
Vehicle Design Section, Mitsubishi Automobile Industrial Company.
-
Murai Masamitsu
Research Laboratory Japan Steel Works Ltd.
-
Takashina Kenzo
Vehicle Design Section Mitsubishi Automobile Industrial Company.
-
Hanzawa Hiroshi
Faculty Of Engineering Hokkaido University
関連論文
- Three-Dimensional Axisymmetric Elastic Stresses in Hollow Pressurized Torus with Varied Thickness
- Three-Dimensional Axisymmetric Elastic Stresses in Hollow Pressurized Torus : Comparison of Shell Theory Solution
- Effects of Couple-Stress on Stress Concentrations of Notched Bar : Indirect Fictitious-Boundary Integral Method
- Elastic Stress Analysis of a Three-Dimensional Crack Using the Layer Potential : (Indirect Boundary Integral Method)
- Three-Dimensional Elastic Stresses of Circular Plate in Couple-Stress Theory : Comparison with Thin-Plate Theory
- Application of the Indirect Fictitious-Boundary Integral Method to Thermal Stress Problems
- A Theoretical Method for Solving Elasto-Plastic Torsion Problem
- On Interference of Circular Notches and Loaded Ends : 2nd Report, Axisymmetric Problems
- Dynamic Interference between a Crack and a Plane Boundary : Dynamic Stress Intensity Factor Induced by a Plane Harmonic SH-wave
- Compression of an Elastic Cylinder Between Two Rigid Planes : Application of the Indirect Fictitious-Boundary Integral Method to a Contact Problem
- Stresses in a Circular Cylindrical Shell Having Two Circular Rigid Inclusions
- Stresses in a Circular Cylindrical Shell Having Two Circular Cutouts
- Three-Dimensional Elastic Stresses in Thick Plate : Comparison with Classical Plate Theory Solution
- One Solution of Three-Dimensional Boundary Value Problems in Linear Classical Elastostatics : Indirect Fictitious-Boundary Integral Method
- On Interference of Circular Notches and Loaded Ends : 1st Report, Plane stress problems
- Bending of a Clamped Thin Circular Plate Having a Rigid Square Column on Its Center
- On the Experimental Plane Elastoplastic Stress Analysis by a Method Combining Birefringent Coating Method and Conducting Sheet Method. : Reinforcing Effect and Assumption for the Strain Normal to the Plane.