On Interference of Circular Notches and Loaded Ends : 2nd Report, Axisymmetric Problems
スポンサーリンク
概要
- 論文の詳細を見る
The problems of the interference of notch and loaded ends which must be considered especially in the material test are discussed quantitatively. For this purpose, in the 2nd report, the cases of a circular cylinder having semicircular groove under several tensile load conditions on its partial surfaces, with the positions varied, are taken up. For the analysis, the point matching method is adopted to obtain the stress field superposed two solutions for each cylinder loaded on its partial surfaces. Furthermore, by the same method of solution, the problems of stress concentration due to circular groove are treated.
- 一般社団法人日本機械学会の論文
著者
-
Kishida Michiya
Faculty Of Engineering Hokkaido University
-
Ueda Shuichi
Sumitomo Heavy Industries
-
HANZAWA Hiroshi
Faculty of Engineering, Hokkaido University
-
Hanzawa Hiroshi
Faculty Of Engineering Hokkaido University
関連論文
- Three-Dimensional Axisymmetric Elastic Stresses in Hollow Pressurized Torus with Varied Thickness
- Three-Dimensional Axisymmetric Elastic Stresses in Hollow Pressurized Torus : Comparison of Shell Theory Solution
- Effects of Couple-Stress on Stress Concentrations of Notched Bar : Indirect Fictitious-Boundary Integral Method
- Elastic Stress Analysis of a Three-Dimensional Crack Using the Layer Potential : (Indirect Boundary Integral Method)
- Three-Dimensional Elastic Stresses of Circular Plate in Couple-Stress Theory : Comparison with Thin-Plate Theory
- Application of the Indirect Fictitious-Boundary Integral Method to Thermal Stress Problems
- A Theoretical Method for Solving Elasto-Plastic Torsion Problem
- On Interference of Circular Notches and Loaded Ends : 2nd Report, Axisymmetric Problems
- Dynamic Interference between a Crack and a Plane Boundary : Dynamic Stress Intensity Factor Induced by a Plane Harmonic SH-wave
- Compression of an Elastic Cylinder Between Two Rigid Planes : Application of the Indirect Fictitious-Boundary Integral Method to a Contact Problem
- Stresses in a Circular Cylindrical Shell Having Two Circular Rigid Inclusions
- Stresses in a Circular Cylindrical Shell Having Two Circular Cutouts
- Three-Dimensional Elastic Stresses in Thick Plate : Comparison with Classical Plate Theory Solution
- One Solution of Three-Dimensional Boundary Value Problems in Linear Classical Elastostatics : Indirect Fictitious-Boundary Integral Method
- On Interference of Circular Notches and Loaded Ends : 1st Report, Plane stress problems
- Bending of a Clamped Thin Circular Plate Having a Rigid Square Column on Its Center
- On the Experimental Plane Elastoplastic Stress Analysis by a Method Combining Birefringent Coating Method and Conducting Sheet Method. : Reinforcing Effect and Assumption for the Strain Normal to the Plane.