Application of the Indirect Fictitious-Boundary Integral Method to Thermal Stress Problems
スポンサーリンク
概要
- 論文の詳細を見る
This paper describes the applicability of the indirect fictitious-boundary integral method to thermal elastic stress problems with simply-connected regions. As examples, a thermal contact problem of notched bar constrained by two hot rigid surfaces in contact with its both end surfaces, and a thermal stress problem of a wall having a concavity (notch) or convexity (protrusion) on one side and heated on either side are treated. As a result, the isothermal line and the thermal stresses are obtained. The influence of shape parameters on stress distributions is also shown.
- 一般社団法人日本機械学会の論文
- 1989-10-15
著者
-
KISHIDA Michiya
Faculty of Engineering, Hokkaido University
-
Kishida Michiya
Faculty Of Engineering Hokkaido University
-
Oda Kenji
Faculty Of Education Fukushima University
-
Sasaki Kazuaki
Faculty Of Engineering Hokkaido University
-
HASHIMOTO Youichi
Engineering & Construction Division, NKK Corporation
-
IN-NAMI Michio
Hokkaido Polytechnic College
-
Hashimoto Youichi
Engineering & Construction Division Nkk Corporation
-
Oda Kenji
Faculty Of Engineering Hokkaido University
関連論文
- Three-Dimensional Axisymmetric Elastic Stresses in Hollow Pressurized Torus with Varied Thickness
- Potassium and Chloride Effluxes during Excitation of Characeae Cells
- Three-Dimensional Axisymmetric Elastic Stresses in Hollow Pressurized Torus : Comparison of Shell Theory Solution
- Effects of Couple-Stress on Stress Concentrations of Notched Bar : Indirect Fictitious-Boundary Integral Method
- Elastic Stress Analysis of a Three-Dimensional Crack Using the Layer Potential : (Indirect Boundary Integral Method)
- Three-Dimensional Elastic Stresses of Circular Plate in Couple-Stress Theory : Comparison with Thin-Plate Theory
- Application of the Indirect Fictitious-Boundary Integral Method to Thermal Stress Problems
- On Interference of Circular Notches and Loaded Ends : 2nd Report, Axisymmetric Problems
- Dynamic Interference between a Crack and a Plane Boundary : Dynamic Stress Intensity Factor Induced by a Plane Harmonic SH-wave
- Compression of an Elastic Cylinder Between Two Rigid Planes : Application of the Indirect Fictitious-Boundary Integral Method to a Contact Problem
- Stresses in a Circular Cylindrical Shell Having Two Circular Rigid Inclusions
- Stresses in a Circular Cylindrical Shell Having Two Circular Cutouts
- Three-Dimensional Elastic Stresses in Thick Plate : Comparison with Classical Plate Theory Solution
- One Solution of Three-Dimensional Boundary Value Problems in Linear Classical Elastostatics : Indirect Fictitious-Boundary Integral Method
- On Interference of Circular Notches and Loaded Ends : 1st Report, Plane stress problems
- Bending of a Clamped Thin Circular Plate Having a Rigid Square Column on Its Center
- On the Experimental Plane Elastoplastic Stress Analysis by a Method Combining Birefringent Coating Method and Conducting Sheet Method. : Reinforcing Effect and Assumption for the Strain Normal to the Plane.