A Fractographic Study of Fatigue Fracture of AISI 4340 Steel
スポンサーリンク
概要
- 論文の詳細を見る
If the topography of fracture surfaces represents the peculiar pattern to various reasons of fracture, the reason could be known by observing them in detail, and further the observation might bring out some information on the fracture mechanism. From the above point of view, we conducted a fractographic investigation on fatigue fracture surface under rotating bending and repeated tension tests. The appearance of the surfaces is apparently different due to their location observed and the stress level in rotating bending test. But the surface pattern from the repeated tension test seemed to be same in the range from the stress at the fatigue limit to rather large stress under which plastic deformation occurs and it closely depends upon the heat-treated structure. The impact fracture surface consists of austenite grains, dimple pattern that shows ductile fracture, and other complex patterns.
- 一般社団法人日本機械学会の論文
著者
-
Nishioka Kunio
Central Research Laboratories
-
Nishikawa Tomio
Central Research Laboratories Sumitomo Metal Industories Ltd.
関連論文
- Fundamental Investigations of Fretting Fatigue : Part 3,Some Phenomena and Mechanisms of Surface Cracks
- Fundamental Investigations of Fretting Fatigue : Part 1,On the Relative Slip Amplitude of Press-fitted Axle Assemblies
- Fundamental Investigations of Fretting Fatigue : Part 4,The Effect of Mean Stress
- Fundamental Investigations of Fretting Fatigue : (Part 5,The Effect of Relative Slip Amplitude)
- Strength of Integral Pipe Flanges : No.2 Gasket Seating Stress and the Influence of Number of Bolts
- Strength of Integral Pipe Flanges : No.1 Stress Distribution in Flange and the Criticism of the Conventional Standards
- Research on the Reinforcement with a Rib : (5th Report, The Deformation of Structural Parts Reinforced with Ribs where the Cross Section of Intersecting Members is Equal)
- Researches on Increasing the Fatigue Strength of Press-Fit Axle : 2nd Report Press-Fitted Shaft Assembly Two Dimensional Photoelasticity
- Researches on Increasing the Fatigue Strength of Press-Fit Shaft : 4th Report, Geometry of the End of Press-Fitting and σ_< w1 >
- The Strength of Railroad Wheels : 1st Report, Thermal Stresses in Disc Wheels
- Research on the Reinforcement with a Rib : (6th Report, The Deformation of Structural Parts Reinforced with Ribs where the Cross Sections of Two Intersecting Members Are Different in Rigidity)
- Fatigue Strengths of Shafts with Press-fitted Collar
- The Effects of Metallurgical Factors on Fatigue Strengths : Part 1,The Effects of Carbon and the Relations between Static Strengths and Fatigue Strengths
- The Effects of Metallurgical Factors on Fatigue Strength : Part 3, The Effects of C, Si, Mn, P and Cu (2)
- Researches on Increasing the Fatigue Strength of Press-Fitted Shaft Assembly
- The Effects of Metallurgical Factors on Fatigue Strength : Part 4, The Effects of N and B
- The Effects of Metallurgical Factors on Fatigue Strength : Part 5, The Effects of Ni, Cr and Mo (1)
- The Effects of Metallurgical Factors on Fatigue Strength : Part 2, The Effects of C, Si, Mn, P and Cu (1)
- The Strength of Railroad Wheels : 2nd Report, The Effect of Wheel Contours on Thermal Stresses in Wheels
- A Fractographic Study of Fatigue Fracture of AISI 4340 Steel