On the Tool Wear in the Intermittent Cutting of the Reinforced Plastics : 1st Report, Wear Behavior in Dry Cutting

スポンサーリンク

概要

• 論文の詳細を見る

• The object of the present paper is to obtain the basic data on the tool wear in the intermittent cutting of the reinforced plastics. Therefore, the tool wear of the double-bladed carbide cutter was studied under various conditions, using the milling tests of the phenolic resin which had an abrasive reinforcement such as fibrous glass and aluminum oxide with no cutting fluid. Some results obtained are as follows : 1. The wear land is not parallel to the cutting direction but appears as a negative clearance. 2. K-class (marked ISO) carbide tool is suitable. 3. In cutting fibrous glass reinforced phenolic resin, the flexural rigidity of the fibrous glass and the cutting condition have great influence on the tool wear. 4. In cutting phenolic resin containing aluminum oxide, both cutting speed and feed rate scarcely affect the tool wear.

• 一般社団法人日本機械学会の論文

著者

• Hanasaki Shinsaku

  Faculty Of Engineering Osaka University

• Hasegawa Yoshio

  Faculty Of Engineering Osaka University

• TSUEDA Masasuke

  Faculty of Engineering, Osaka Institute of Technology

• Tsueda Masasuke

  Faculty Of Engineering Osaka Institute Of Technology

関連論文

• Analysis of CFRP Cutting by Finite Element Method II
• On the Tool Wear in the Intermittent Cutting of the Reinforced Plastics : 3rd Report, Effect of the Cutting Fluid on the Tool Wear
• Drilling Performance of New Type Twist Drill
• On the Tool Wear in the Intermittent Cutting of the Reinforced Plastics : 2nd Report, Rheological Study of the Action of the Abrasive Reinforcement on the Tool Wear
• On the Tool Wear in the Intermittent Cutting of the Reinforced Plastics : 1st Report, Wear Behavior in Dry Cutting
• Multi-Regression Analysis of the Grinding Force in Steel : Vibration, Control Engineering, and Engineering for Industry, New materials, new energy, biotechnology, electronics, etc.

スポンサーリンク