A Study on AFH
スポンサーリンク
概要
- 論文の詳細を見る
The subject of this paper is to make clear the basic characteristics of the AFH. To calculate the characteristics of the AFH with single conduit, the AFH containing a separator and the three-phase AFH, three matrices, namely exact matrix, approximated matrix using the Poiseuille's law and matrix approximated by lumped parameters, are considered. When the input frequency of the AFH is lower than the fundamental characteristic frequency of the conduit, the calculations based upon the approximated matrices induce no important error. The frictional force on the separator caused by the sealing material lowers remarkably the power transmission efficiency of the AFH. With the three-phase AFH, the pressure variation does not become sinusoidal even if the displacement of the input pistons is sinusoidal. In this case a high input frequency can not be taken because some resonance will be induced in the system by a higher harmonics in the pressure wave.
- 一般社団法人日本機械学会の論文
著者
-
Takenaka Toshio
Tokyo Institute Of Technology
-
Kato Ikuo
Sony Products Co. Ltd.
-
Urata Eizo
Tokyo Institute Of Technology
-
AKIYAMA Sadami
Makino Milling Machine Co., Ltd.
-
AKASHI Teruo
Toyota Automobile Products Co., Ltd.
-
SHOJI Morio
Mitsubishi Electric Co., Ltd.
-
Akashi Teruo
Toyota Automobile Products Co. Ltd.
-
Akiyama Sadami
Makino Milling Machine Co. Ltd.
-
Shoji Morio
Mitsubishi Electric Co. Ltd.
関連論文
- On the Phase Transition in Cuprous Iodide
- Flow Measurement of Water Turbine by Means of Salt Dilution Method
- Unsteady Flow of Gas in Long Circular Tube
- A Study on AFH
- On the Effect of Trapped Air in a Liquid Conduit on the Transient Flow Rate
- An Investigation of Oil Column Separation in the Return Line of Large Free Forging Press
- Study on the High Pressure Generation by Means of Oil Hammer : 1st Report, Fundamental Properties of Repeated High Pressure Generator
- On the Transient Behavior of Oil Flow under Negative Pressure
- Study on the High Pressure Generation by Means of Oil Hammer : 2nd Report, Application to a Pressure Intensifier and Lateral Pressure Cutting
- A New Design of Float-Type Variable Area Flowmeter
- The Frequency Response of a Loaded Hydraulic Servomechanism
- Thrust of the Disc Valves