On the Phase Transition in Cuprous Iodide
スポンサーリンク
概要
- 論文の詳細を見る
The phase transition and the crystal structures of cuprous iodide (CuI) have been studied by the X-ray and calorimetric measurement Two phase transitions at 369℃ and 407℃ were found and the corresponding energy and entropy changes were estimated from the specific heattemperature curve. The crystal lattice of γ, β and α-phases were determined to be the cubip (ZnS type), hexagonal (ZnO type) and cubic, respectively, by the X-ray powder method. The intensity change with temperature was measured in detail by a new method by which the begins temperature factor can be taken into account more exactly. From this measurement, it was found that the crystal structure of this substance begins to change anomalously already at about 200℃, and finally transforms into the high temperature form having an average structure. That is to say, there are some metastable positions around every copper position of the low temperature form and the probability of finding the Cu-atoms in these positions gradually increases with temperature and finally, in the α-Phase region, the atorns are equally distributed over all the positions. It was concluded that these probable positions are 4(c): (1/4 1/4 1/4) and 16(e): (xxx, xxx*, xxx, xxx) of 'T_a^2 with the parameter x〓0.34±0.01. The entropy change expected from this proposed structure change is fairly in agreement with the value obtained by the calorimetric measurement.
- 社団法人日本物理学会の論文
- 1952-02-25
著者
-
HOSHINO Sadao
Tokyo Institute of Technology
-
Takenaka Toshio
Tokyo Institute Of Technology
-
Miyake Shizuo
Tokyo Institute Of Technology
関連論文
- On the Phase Transition in Lead Titanate.
- On the Phase Transition in Cuprous Iodide
- X-ray Studies on the Structures of Solid Solutions NaCl-CaCl_2 I. Main Results and General Considerations
- Crystal Structure of Lead Titanato and of Lead-Barium Titanate
- Flow Measurement of Water Turbine by Means of Salt Dilution Method
- A Study on AFH
- On the Effect of Trapped Air in a Liquid Conduit on the Transient Flow Rate
- An Investigation of Oil Column Separation in the Return Line of Large Free Forging Press
- Study on the High Pressure Generation by Means of Oil Hammer : 1st Report, Fundamental Properties of Repeated High Pressure Generator
- On the Transient Behavior of Oil Flow under Negative Pressure
- Study on the High Pressure Generation by Means of Oil Hammer : 2nd Report, Application to a Pressure Intensifier and Lateral Pressure Cutting
- Crystal Structure and Phase Transition of Some Metallic Halides (III) : Structure Anomaly in α-Ag_2HgI_4
- Thrust of the Disc Valves