An Investigation of Oil Column Separation in the Return Line of Large Free Forging Press
スポンサーリンク
概要
- 論文の詳細を見る
In a large free forging press, the high speed operation of a directional control valve often causes an oil column separation in the return line just after the valve. The process of oil column separation from the start of valve operation to the contact of oil columns is analyzed by the numerical calculation, and the relation between the valve closing time of linear closing mode and the surge pressure due to the contact of the oil columns is obtained. The expression of flow characteristic of the valve can be simplified by use of an effective stroke of the valve. The general relations between the oil column separation caused by the linear mode closing of the valve and the dimensionless parameters which describe the characteristic of pipe system are obtained.
- 一般社団法人日本機械学会の論文
著者
-
Takenaka Toshio
Tokyo Institute Of Technology
-
KITAGAWA Ato
Tokyo Institute of Technology
-
Arai Sumio
Arai Engineering Office
関連論文
- On the Phase Transition in Cuprous Iodide
- Flow Measurement of Water Turbine by Means of Salt Dilution Method
- A Study on AFH
- On the Effect of Trapped Air in a Liquid Conduit on the Transient Flow Rate
- An Investigation of Oil Column Separation in the Return Line of Large Free Forging Press
- 2P2-D06 Development of a Throw & Collect type Rescue Inspector : 5^ Report : Improvement in the Access Technology in a Collapsed House
- Study on the High Pressure Generation by Means of Oil Hammer : 1st Report, Fundamental Properties of Repeated High Pressure Generator
- On the Transient Behavior of Oil Flow under Negative Pressure
- A Method or Absorption for Surge Pressure in Conduits
- Study on the High Pressure Generation by Means of Oil Hammer : 2nd Report, Application to a Pressure Intensifier and Lateral Pressure Cutting
- Thrust of the Disc Valves