Study on Formate Grinding Method of Constant Depth Tooth Spiral Bevel Gears : (By No. 0 Cutter and Non-Tilting Cutter Shaft)

スポンサーリンク

概要

• 論文の詳細を見る

• In this report, a cutting and grinding method of constant depth tooth spiral bevel gears is described, i.e. the gear is formated by the Gleason's No. 0 cutter or grinding wheel having an equal pressure angle on inner and outer blades and the pinion is generated by the No. 0 cutter or grinding wheel whose shaft is not tilted to the rotor axis. In generating the pinion, the pinion blank and the rotor are rotated at the rate of the number of teeth of the pinion to that of the crown gear and at the same time the pinion blank is driven away from the rotor and moreover approached to it. By this method, although it is an approximate one, a good available tooth bearing with a crowning and a profile modification can be obtained on one trial of grinding by the No. 0 wheel only, consequently a mass and small quantity grinding production system of bevel pairs could be achieved.

• 一般社団法人日本機械学会の論文

著者

• Kondo Seizo

  College Of General Education Kyushu University

• Kondo Seizo

  College Of General Education Kyushu University.

関連論文

• Study on the Cutting Forces for Spiral Bevel Gears
• Analyses of Cutting Conditions of Spiral Bevel Gears
• Study on Formate Grinding Method of Constant Depth Tooth Spiral Bevel Gears : (By No. 0 Cutter and Non-Tilting Cutter Shaft)

スポンサーリンク