Investigation about Load Capacity of Nylon Gears, When Tooth Surface Finishing of Mating Steel Gears is different. : 1st Report ; Results of Load Test at Cylinder
スポンサーリンク
概要
- 論文の詳細を見る
There are many reports on fundamental experiment of "Nylon-Steel" abrasion. But these are a little used for actual gear. This report discusses a nylon gear meshing with a hobbed steel gear and a ground steel gear. The load test of nylon cylinder was performed using a steel cylinder which has a different surface finishing. The abrasion, the allowable limit load, the surface temperature, the modes of breakage of nylon cylinder owing to a difference of a surface finishing of steel cylinder were investigated and useful data for design of nylon gear were collected.
- 一般社団法人日本機械学会の論文
著者
関連論文
- Investigation about the Strength of Plastic Gears : 5th Report; Abrasion of Nylon Gear due to the Difference in Materials of Mating Gears.
- Development of Low-Noise Gears : Silencing Effect and Operating Characteristics of Polyamide Elastomer Gears
- A Study on Development of Low Noise Gears : Silencing Effect and Operation Characteristics of Nylon Gears Filled with Plasticizers
- Water Lubrication Characteristics of Polyacetal Gears Filled with Carbon Fibers
- Dimensional Change in Plastic Gears in Vacuum and Some Experimental Results
- Basic Characteristics of Plastic Gears Lubricated with Water
- A Study on Strength Design Methods for Plastic Gears : Estimation of Operation Life of Plastic Gears Elevated-Temperature Environment
- Fundamental Characteristics of Plastic Gears Made of Thermoplastic Resin Filled with Various Fibers
- A Study for the Development of Plastic Worm Gears : Plastic Worm Gears filled with Fiber and Solid Lubricant
- Investigation about the Prevention of Tooth Profile Change of Nylon Gears : 3rd Report, Wear and Tooth Profile Change in Profile Shifted Nylon Gears
- Investigation about the Prevention of Tooth Profile Change of Plastic Gears : 2nd Report; Abrasion and tooth profile change of nylon gears, reinforced with a stiffener
- Development of Plastic Gears for Power Transmission : Various Methods of Lengthening the Life of Plastic Gears and Their Effect
- Argument on Plastic Gears for Power Transmission
- Investigation about the Strength of Plastic Gears : 4th Report ; Abrasion and State of Tooth Profile Change of Driven Nylon Gear
- Investigation about the Strength of Plastic Gears : 1st Report, The Strength of Nylon Gears which have Counter-Crowning
- Investigation about the Strength of Plastic Gear : 2nd Report ; Abrasion of the Nylon Gear for Power Transmission, Meshing with the Steel Gear
- Noise and Transmission Efficiency under Deformation of Tooth Form of Nylon Gear
- Investigation about Load Capacity of Nylon Gears, When Tooth Surface Finishing of Mating Steel Gears is different. : 1st Report ; Results of Load Test at Cylinder
- Investigation about the Strength of Plastic Gears : 3rd Report ; Strength of the Nylon Gear meshing with the Steel Gear which was cut by Semitopping Hob
- Investigation about the Strength of Plastic Gears : 6th Report, Endurance Limit and Damage State of Nylon Gear for Power Transmission
- Investigation about the Prevention of Tooth Profile Change of Plastic Gears : 1st Report; Amount of Profile Modification of the Steel Gear, which Meshed with the Nylon Gear
- Investigation about Load Capacity of Nylon Gears, when Tooth Surface Finishing of Mating Steel Gears is different : 2nd Report; Abrasion of Nylon Gear Meshing with Ground Steel Gear