Vibration Analysis by Substructure Synthesis Method : Part 4, Calculation of Residual Compliance Matrix
スポンサーリンク
概要
- 論文の詳細を見る
The authors propose a method for calculating accurately the residual compliance matrix of structures with free-free boundary condition in this paper. A total structure must be divided into several substructures when it is analyzed by substructure synthesis methods. In doing this, the majority of the substructure will be under free-free boundary condition. For such substructure the residual compliance matrix cannot be obtained accurately by the usual method. So it is important to propose a new method for calculating the accurate residual compliance matrix of the structures with free-free boundary condition. Algorithms of the usual method and the method proposed by the authors as well as Hansteen are given. Numerical examples about a simple case are also shown.
- 一般社団法人日本機械学会の論文
著者
-
OOKUMA Masaaki
Faculty of Engineering, Tokyo Institute of Technology
-
Nagamatsu Akio
Faculty Of Engineering Tokyo Institute Of Technology
-
Nagamatsu Akio
Faculty O F Engineering Tokyo Institute Of Technology
-
Ookuma Masaaki
Faculty Of Engineering Tokyo Institute Of Technology
関連論文
- Experimental Identification of Mechanical Structure with Characteristic Matrices : Part 1. Proposition and Basic Approach
- Research on Simulation of the Robot : 2nd Report, Numerical Analysis of Force
- Research on Simulation of the Robot : 1st Report, Numerical Analysis of Displacement, Velocity and Acceleration
- Analysis of Vibration by Substructure Synthesis Method : Part 3, Application to Diesel Generator Package
- Analysis of Forced Vibration by Reduced Impedance Method : Part. 4 Proposition and application of multiple reduced impedance method
- Vibration Analysis on Bladed Disk Assemblies of Axial-flow Turbines
- Model Parameter Estimation with Multi-reference Curve Fitting : Vibration, Control Engineering, Engineering for Industry
- Comparison of Component Mode Synthesis Method with MSC-NASTRAN
- Research on Modal Analysis : 4th Report, Multi Reference Curve Fitting-(Part 1)
- Analysis of Vibration by Substructure Synthesis Method : Part.1 Basic Approach
- Basic Research on Vibration and Noise of Internal Combustion Engine : 2nd Report, Noise Analysis of Cylinder Block
- Research on Modal Analysis : 1st report, General Purpose Program of Curve Fitting and Basic Study
- Basic Research on the Vibration and Noise of an Internal Combustion Engine : 3rd Report, Acoustic Analysis of the Cylinder-crank System
- Vibration Analysis of Movable Part of Internal Combustion Engine : Part 1. Crank Shaft
- Basic Research on Vibration and Noise of Internal Combustion Engine : 1st Report, Vibration Analysis of the Piston-Crank System I
- Vibration Analysis by Substructure Synthesis Method : 5th Report, Method with identified Characteristic Matrices
- Analysis of Forced Vibration with Reduced Impedance Method : Part l, Introduction of Analytical Procedure
- Vibration Analysis by Component Mode Synthesis Method (Comparison of Three Methods (1)
- Analysis of Forced Vibration by Reduced Impedance Method : Part. 3 Damped Vibration
- Estimation of Variance of the Frequency Response Function and its Application to the Curve Fit
- Research on Simulation of the Robot : 3rd Report, Vibration Analysis, Part 1
- Analysis of Forced Vibration by Reduced Impedance Method : Part 2. Introduction of New Curve Fitting Technique
- Estimation of Variance of the Frequency Response Function in Experimental Modal Analysis
- Recent Advances of Modal Analysis in Japan
- Vibration Analysis by Multiple Component Mode Synthesis Method
- Analysis of Vibration by Component Mode Synthesis Method : Part 4, Natural Frequency and Natural Mode (II)
- Vibration Analysis by Substructure Synthesis Method : Part 4, Calculation of Residual Compliance Matrix
- Analysis of Vibration by Component Mode Synthesis Method : Part 5, Force Vibration II