Incipient Phenomena of Frost Formation
スポンサーリンク
概要
- 論文の詳細を見る
Experiments have been performed to investigate the effect of cooled-plate characteristic on frost formation under the condition of forced convection. Two kinds of plates having the different contact angles to water, were utilized. Special attention was focused on the incipient phenomena of the effect of the plate contact angle to water on the frost forming on the cooled plate. It was found that when the temperature difference between the cooled plate and the dew point of air stream, was less than about 1.50c the frost thickness might never build up greater than 0.5mm.
- 一般社団法人日本機械学会の論文
著者
-
Fukusako Shoichiro
Faculty Of Engineering Hokkaido University
-
Seki Nobuhiro
Faculty Of Engineering Hokkaido University
-
Uemura Shigeru
Daikin Kogyo Co. Ltd.
-
MATSUO Kuniyuki
Faculty of Engineering, Hokkaido University
-
Matsuo Kuniyuki
Faculty Of Engineering Hokkaido University
関連論文
- A Numerical Study on Transient Heat Transfer in a Vertical Porous Layer
- A Study on Transient Characteristics of Natural Convective Heat Transfer in a Confined Rectangular Cavity Packed with Porous Media
- Heat Transfer by Natural Convection in a Shallow Rectangular Cavity with Two Opposing Vertical Walls at Different Temperatures
- The Behaviour of the Temperature-Velocity Fluctuations and the Turbulent Prandtl Number in the Developing Thermal Turbulent Boundary Layer on a Flat Plate
- Incipient Phenomena of Frost Formation
- Experimental Studies on the Melting of a Horizontal Ice Layer
- Drying Phenomena of a Horizontal Wetted Porous Layer Under High Heat Flux
- Convective Instability in a Porous Medium Heated From Below
- Effect of Buoyancy on Laminar Developing Flow Between Parallel Plates
- Effect of Non-Uniform Inlet Velocity Profile on the Development of a Laminar Flow between Parallel Plates
- Laminar Swirling Flow in the Entrance Region of a Circular Pipe
- Laminar Wall Jet of an Electrically Conducting Fluid in the Presence of a Transverse Magnetic Field
- Characteristics of the Freezing Heat Transfer of Layered Air-Water Flow in a Circular Tube
- Boiling Heat-Transfer Performance at Critical Water Level in a Porous Bed