On the Characteristics of a Bolted Joint with Tap Bolts : the case where a clamped part is a T-flange

スポンサーリンク

概要

• 論文の詳細を見る

• This paper deals with distributions of the contact stresses when a T-flange is fastened with tap bolts to a base which is large enough compared with the T-flange. In an analysis, by replacing a T-flange and a base with two finite strips respectively, the distribution of contact stresses is analyzed as a two body contact problem using two dimensional theory of elasticity. In order to know the distribution of contact stresses near a bolt hole, the contact stress between two hollow cylinders is analyzed using three dimensional theory of elasticity. In addition. the force ratio, that is the ratio of an increment of a bolt axial force to a load when the load is applied, is analyzed. Moreover, taking a bending moment caused in a bolt into consideration the maximum stress is also analyzed. For verification of analyses, experiments are carried out and it is shown that analytical results are in a fairly good agreement with experimental ones.

• 一般社団法人日本機械学会の論文

著者

• KOBAYASHI Takashi

  Faculty of Science and Engineering, Doshisha University

• Sawa Toshiyuki

  Faculty Of Engineering Yamanashi University

• Hagiwara Takanori

  Faculty Of Engineering Yamanashi University

• Kobayashi Takashi

  Faculty Of Engineering Keio University

関連論文

• Compact Multimode Horn with Coaxial Corrugation for Circular Coverage
• Effects of the Interface Configurations on the Characteristics of Bolted Joints : the case where clamped parts are T-flanges
• A Simple Method to Calculate the Force Ratio of Bolted Joints : The case where clamped parts are circular flanges and pipe flanges
• Measurements of the Isobaric Specific Heat Capacity of Gaseous Carbon Dioxide from 245K to 345K up to 3.7MPa
• A Self-Confirming Engine for Preventing Man-in-the-Middle Attack(Security)(Internet Technology IV)
• On the Characteristic of a Bolted Joint Subjected to an External Bending Moment : the case where clamped parts are circular flanges
• On the Characteristics of a Bolted Joint with Tap Bolts : the case where a clamped part is a T-flange
• Considerations on the Improvement of the Stiffness of Bolted Joints in Machine Tools
• A Study on the Bending Rigidity of an Adhesive Joint Subjected to a Bending Load Tangential to Bonding Surfaces
• On the Characteristics of a Bolted Joint with Tap Bolts : the case where a clamped part is a cover of a pressure vessel
• On the Characteristics of a Bolted Joint with Tap Bolts : the case where a clamped part is a circular flange
• The Strength of Combination Joints of an Adhesive with Bolts (T-Flange Adherends Subjected to an External Bending Moment)
• Effects of Magnetic Field on Metabolic Action in the Peripheral Tissue

もっと見る 閉じる

スポンサーリンク