A Study on the Bending Rigidity of an Adhesive Joint Subjected to a Bending Load Tangential to Bonding Surfaces
スポンサーリンク
概要
- 論文の詳細を見る
The deformation characteristics of a cantilever beam structure, in which a beam was bonded onto a base using a bonding surface parallel to the axis of the beam and which was subjected to a bending load tangential to the bonding surfaces, have been examined both theoretically and experimentally. It was shown that the deformation and rigidity of the adhesive joint could be well estimated by using the theory of bending of a beam on an elastic foundation. Effects of the length of the flange and the thickness of the adhesive layer on the rigidity were clarified, and a design criterion of adhesive joints was proposed. It was observed that the rigidity of the adhesive joint was greater than that of the bolted joint when the thickness of the adhesive layer was thin, and that greaterload could be applied to an adhesive joint than to a bolted joint.
- 一般社団法人日本機械学会の論文
- 1991-12-15
著者
-
KOBAYASHI Takashi
Faculty of Science and Engineering, Doshisha University
-
Matsubayashi Tsuneo
Faculty Of Engineering Nagoya University.
関連論文
- Compact Multimode Horn with Coaxial Corrugation for Circular Coverage
- Measurements of the Isobaric Specific Heat Capacity of Gaseous Carbon Dioxide from 245K to 345K up to 3.7MPa
- A Self-Confirming Engine for Preventing Man-in-the-Middle Attack(Security)(Internet Technology IV)
- On the Characteristics of a Bolted Joint with Tap Bolts : the case where a clamped part is a T-flange
- Considerations on the Improvement of the Stiffness of Bolted Joints in Machine Tools
- A Study on the Bending Rigidity of an Adhesive Joint Subjected to a Bending Load Tangential to Bonding Surfaces
- On the Dynamic Behavior of Machine Tool Slideway : 1st Report, Characteristics of Static Friction in "Stick Slip" Motion
- On the Dynamic Behavior of Machine Tool Slideway : 3rd Report, Pitching and Yawing Motion of Moving Element Caused by Stick Slip
- On the Characteristics of a Bolted Joint with Tap Bolts : the case where a clamped part is a cover of a pressure vessel
- On the Characteristics of a Bolted Joint with Tap Bolts : the case where a clamped part is a circular flange