A Penalty Shifting Method for Constrained Optimal Control Problems
スポンサーリンク
概要
- 論文の詳細を見る
For nonlinear programing problems with equality constraints, Powell has proposed a new sequential unconstrained method. This paper extends the method to the optimal control problems with both equality and inequality constraints. The following results are obtained. 1. The convergence of the method is proved under a few assumptions. 2. The optimal solution is obtained as finite values of parameters. Therefore, numerical difficulties can be avoided in the minimization of the penalty function. 3. The optimal values of parameters are closely related to the optimal Lagrange multipliers. 4. The convergence to the optimal solution can be forced to be rapid by increasing the parameters corresponding to penalty coefficients. Finally, The efficiency and the accuracy of this method are investigated on a problem.
- 一般社団法人日本機械学会の論文
著者
-
Fujimoto Hideo
Nagoya Institute Of Technology
-
FUJII Seizo
Nagoya Institute of Technology
-
Ono Michio
Toray Co. Ltd.
-
Fujii Seizo
Nagoya Institute Technology
-
Fujimoto Hideo
Nagoya Institute Technology
関連論文
- 3-B-7 APPLYING THE TOC PROJECT MANAGEMENT TO OPERATION AND MAINTENANCE SCHEDULING OF A RESEARCH VESSEL
- Improvement of the Convergence Rate in the Transformation Method for Constrained Optimal Control Problems and its Application
- Improvement of Convergence Rate of the Transformation Method for Constrained Optimization Problems
- On a Discontinuous Optimizing Control by Correlation Method
- Dynamic Characteristics of Fluid Temperature Between Inlet and Outlet of a Room : 1st Report, The Case of Two-Dimensional Room
- Transformation Methods of an Exponential Function Type for the Optimal Control Problems with Constraints : 1st Report, A Method with One Correcting Parameter
- A Penalty Shifting Method for Constrained Optimal Control Problems
- Foreword(Advanced Production Scheduling)
- An Improvement of an Interactive Multiobjective Optimization Methnd and Its Application to the Optimal Design
- Foreword(Advanced Production Scheduling)
- 2-A-2 THE TIME BREAKTHROUGH STRATEGY FOR SCM
- Considerations of a Penalty Shifting Method for Nonlinear Programming Problems
- Applying the TOC Project Management to Operation and Maintenance Scheduling of a Research Vessel(Advanced Production Scheduling)
- Analysis and Experiment of Helical Spring-Type Pressure and Shear Sensor
- Cognitive Control Based Realisation of Human Skill Algorithms
- Dynamic Characteristics of Fluid Temperature in a Duct of Air Conditioning Systems
- New Multi-d.o.f. Haptic Device Using a Parallel Mechanism with a Wide Rotational Working Area