Strength Evaluation of Sintered Silicon Nitride Ceramics by means of a New Test System at Elevated Temperatures
スポンサーリンク
概要
- 論文の詳細を見る
A test system for precisely evaluating the tensile strength of ceramics at elevated temperatures was newly developed. Four-point bending and tensile tests were performed on sintered silicon nitride ceramics in the temperature range from room temperature to 1300℃. The track of a ductile fracture was observed on the fractured surfaces of the tensile specimens tested at temperatures above 11OO℃, suggesting the occurrence of plastic deformation. The fracture stress of bending specimens was about 1.18-1.43 times as large as that of tensile specimens. The test temperature dependency, however, was very similar in both the fracture stresses throughout the entire test temperature range. The fracture toughnesses from tensile and bending specimens were almost the same in the test temperature range from R.T. to about 800℃. The fracture toughness obtained from the chevron-notch-type specimen was almost coincident with that from the Knoop-indented specimen in the temperature range from R.T. to 900℃. There was, however, some difference at temperatures above this, suggesting the occurrence of adhesion at the crack tip in the Knoop-indented specimen.
- 一般社団法人日本機械学会の論文
- 1990-10-15
著者
-
Hatanaka Kenji
Department Of Biomaterials Okayama University Graduate School Of Medicine Dentistry And Pharmaceutic
-
Ando T
Kanebo Corp. Osaka Jpn
-
Fujimitsu T
Department Of Mechanical Engineering Yamaguchi University
-
Fujimitsu Tatsuro
Department Of Mechanical Engineering Faculity Of Engineering Yamaguchi University
-
Ando Takayuki
Department Of Applied Bio-organic Chemistry Gifu University
-
TACHIBANA Teruo
Ube Industries Ltd.
-
NAKAI Kaichiro
Ube Industries Ltd.
関連論文
- Low Cycle Fatigue Strength of Copper and α-brass Cold-worked
- Fatigue Strength in Long Life Range and Non-propagating Fatigue Crack in SUS 304 Type Stainless Steel
- Esophageal Small-cell Carcinoma with Syndrome of Inappropriate Secretion of Antidiuretic Hormone
- Effect of Thermocycling on Inter facial Gap-formation in Class V Cavities and Mechanical Properties of Spherical Silica Filler Addition to Resin-modified Glass Ionomer Restorations
- Effect of Spherical Silica Filler Addition on Immediate Interfacial Gap-formation in Class V Cavity and Mechanical Properties of Resin-modified Glass-ionomer Cement
- Effect of Grain Size on Low Cycle Fatigue in Low Carbon Steel
- An Analysis of Cyclic Deformation Based on Dislocation Dynamics in Copper
- An Effective Plastic Strain Component for Low Cycle Fatigue in Metals
- Some Considerations of Frequency and Wave Form Effects in Fatigue of Copper Based on Dislocation Dynamics
- High Temperature Creep under Bend Loading in Si-Ti-C-O Ceramic Fiber Bonded Body
- A Numerical Simulation on Strength of Si-Ti-C-O Fiber Bonded Ceramics
- Initiation of High Temperature Creep Voids in Notched Components
- Analysis of Bending Creep Behavior of Silicon Nitride Ceramics at Elevated Temperature
- An Analysis of Surface Crack Growth in Circumferentially Grooved Components under Low-Cycle Fatigue
- Interstitial cells of Cajal do not harbor c-kit or PDGFRA gene mutations in patients with sporadic gastrointestinal stromal tumors
- シアル酸と糖鎖生物学 : 化学的アプローチ
- Size Effect on Rotating Bending Fatigue in Steels
- Assessment of J-Integral for Three-Dimensional Surface Crack at Notch Root
- An Analysis of the Stress-Strain Hysteresis Loop and the Cyclic Stress-Strain Response of Steels Based on Dislocation Dynamics : 2nd Report, Estimations of Hysteresis Loop, Cyclic Stress-Strain Curve and Low Cycle Fatigue Life through the Presented Analys
- An Analysis of the Stress-Strain Hysteresis Loop and the Cyclic Stress-Srrain Response of Steels, Based on Dislocation Dynamics : 1st Report, Derivation of Analytical Equations and Some Analyzed Results
- Biaxial Deformation Behaviors of C/C Composite at High Temperatures
- A Numerical Calculation of Cyclic Deformation Accompanied by Strain Range Variation and Subsequent to Tensile Deformation in Terms of Dislocation Dynamics in Copper
- Optimum Design of Sintered Silicon Nitride Ceramics Specimen with Projections for High-Temperature Creep Test
- Strength Evaluation of Sintered Silicon Nitride Ceramics by means of a New Test System at Elevated Temperatures
- Short Crack Growth under Low Cycle Fatigue and Effect of Prior Cyclic Deformation on It in Steels
- The Effect of Mean Stress and Strain on Crack Growth and Crack Closure in Low-Cycle Fatigue
- Some Considerations on Low Cycle Fatigue Under Axial and Diametral Strain Controlled Conditions : Series A : Solid-Mechanics, Strength of Materials
- Tensile Test of Sintered Silicon Nitride Ceramic at Elevated Temperatures
- Cyclic Stress-Strain Response and Low-Cycle Fatigue Life in Metallic Materials
- Determination of Abundance Ratio of H and D in Heavy Water by Means of Thermogravimetric Analysis for Cu (II) Sulphate Pentahydrate