Fe-Cr-Ni 合金における前加工をうけたオーステナイトのマルテンサイト変態誘起塑性

概要

論文の詳細を見る
The martensitic transformation-induced plasticity (TRIP phenomenon) of pre-deformed austenite in Fe-15% Cr-12% Ni alloy (M_s<room temperature) was investigated by means of tensile test at various temperatures between -196゜〜+120℃. As pre-deformation, the reduction of 0〜80% was given by rolling at 200℃. Since the rolling temperature was above M_d temperature of the specimen, all specimens consisted of austenitic single phase even after rolling at 200℃. The TRIP was observed in the pre-deformed austenite as well as in the non-predeformed one, and the maximum elongation appeared at a certain temperature between M_d and M_s. The M_s temperature decreased with increasing the degree of pre-deformation. Accordingly, as the degree of pre-deformation increases, the range of temperature showing the TRIP phenomenon became narrower and the temperature at which the maximum elongation appeared shifted toward the lower temperature. While the strength of austenite (especially the 0.2% proof stress) at 120℃ was markedly increased by rolling, at the same time the elongation became smaller. However, the elongation of pre-deformed austenite was enhanced when the TRIP occurred. For example, the elongation of the specimen given a pre-deformation of 80% was only 5% at 120℃ (above M_d), but it was increased to 57% by TRIP at -196℃. It was found that the amount of increase in elongation by TRIP, which is the difference between the elongation value at the temperature showing maximum TRIP and that at the temperature of austenitic state, was almost constant (about 50%) independently of the degree of pre-deformation of austenite. Therefore, it is possible to obtain the optimum condition that the alloy shows high strength and ductility by TRIP after pre-deformation of austenite. The yield point and plateau stage similar to Luders strain were observed in the stress-strain curves of pre-deformed specimens. These phenomena became to appear more distinctly with increasing the degree of pre-deformation and with decreasing the test temperature.
社団法人日本材料学会の論文
1973-04-15

Fe-Cr-Ni 合金における前加工をうけたオーステナイトのマルテンサイト変態誘起塑性

スポンサーリンク

概要

著者

関連論文

スポンサーリンク