発泡スチロールの衝撃による圧縮応力─ひずみ特性
スポンサーリンク
概要
- 論文の詳細を見る
This paper presents the dynamic stress-strain properties of styrofoams. Two ballistic pendulums were used in this experiment. The specimens, which had been bonded on the end surface of the pendulum being impacted, were loaded by the impact pendulum. The acceleration-time curves induced in the impacted pendulum were measured. The dynamic stress and strain were calculated by integrating these acceleration-time curves numerically. The effects of the strain rates and the number of impact loadings in the dynamic properties of styrofoams were examined and the accuracy of the test result was also discussed. The results obtained are as follows : (1) The dynamic stress-strain properties of foamed plastics can be obtained with the accuracy of about 3 percent by this experimental method. (2) The strength and stiffness of styrofoams increase with increasing the strain rate up to about 20/sec, beyond which they start to decrease. (3) The stiffness of styrofoams is remarkably reduced by the first application of impact loading but does not change any more by its further successive applications. (4) At the strain rate of about 35 〜40/sec, styrofoams disintegrate in an explosive manner. Therefore, the styrofoams seem to have the critical deformation rate in the vicinity of this strain rate.
- 社団法人日本材料学会の論文
- 1973-02-15
著者
関連論文
- 短絡時の回転機固定子巻先端部の変形挙動と強度
- 回転機固定子巻線の繰返し曲げ荷重下における変形ならびに破壊挙動
- 回転機固定子巻線の曲げ変形ならびに破壊挙動
- 回転機固定子巻線の導体と絶縁物の間の力の伝達機構の検討
- 衝撃荷重を局部的に受ける場合の発泡スチロールの動的圧縮応力-ひずみ特性
- 発泡スチロールの衝撃による圧縮応力─ひずみ特性
- 熱サイクルによる回転機固定子巻線の破壊機構
- 多翼ファンの設計技術に関する研究 : 第1報,定常回転時に羽根に生じる応力の発生メカニズム
- テープと接触するヘッドの摩耗形状に関する研究 : 第2報, 解析法の検討
- テープと接触するヘッドの摩耗形状に関する研究 : 第1報, 実験的検討
- デザインテクノロジーの必要性
- 超伝導材料, 堂山昌男, 山本良一(編), 伊原英雄, 戸叶一正(著), 1987年, 東京大学出版会発行, A5判, 350ページ, 3200円
- 1986年, Kokon Shoin発行, 150x230mm, 897ページ, 20,000円(粉体小特集)
- 設計のエキスパート化に伴う材料強度評価技術の在り方
- 325 回転機固定子巻線用含浸レジンの接着強度の半実験的解析法による検討