短絡時の回転機固定子巻先端部の変形挙動と強度
スポンサーリンク
概要
- 論文の詳細を見る
A stress measurement technique was developed in order to reduce the disturbance caused by electromagnetic field. Using this technique, a series of short circuit tests were carried out on 21 000 kVA two-pole turbine generators. The stress and displacement induced on the stator end windings were examined under various short circuit voltages. The mechanical strength of the stator end wind-ings was discussed in comparison with the measured stress and the bending strength of stator windings and was also discussed in relation to the variations in tangent delta and breakdown voltage characteristics. The results obtained are as follows. (1) The stress measurement technique developed in this study is effective for the stress measure-ment on electric appliances which are exposed to strong magnetic field. (2) The stator end windings can be bent repeatedly tangentially in the direction to increase the stator end windings' curvature and radially in the opposite direction to the rotor. (3) The maximum amplitudes of stress and displacement of the stator end windings increase in proportion to the square of short circuit voltage. But they depend on the magnitude of the direct component in short circuit current and tend to increase with it. (4) When the direct current component appears relatively large, the predominant frequency of the stress and displacement is 60Hz, but with decreasing of direct current component 120Hz frequency becomes predominant. When it is small, 120Hz frequency is predominant. (5) It is considered that within this test condition there is no mechanical damage which would cause the reduction of electric characteristics under further service operation.
- 社団法人日本材料学会の論文
- 1977-07-15
著者
関連論文
- 短絡時の回転機固定子巻先端部の変形挙動と強度
- 回転機固定子巻線の繰返し曲げ荷重下における変形ならびに破壊挙動
- 回転機固定子巻線の曲げ変形ならびに破壊挙動
- 回転機固定子巻線の導体と絶縁物の間の力の伝達機構の検討
- 衝撃荷重を局部的に受ける場合の発泡スチロールの動的圧縮応力-ひずみ特性
- 発泡スチロールの衝撃による圧縮応力─ひずみ特性
- 熱サイクルによる回転機固定子巻線の破壊機構
- 多翼ファンの設計技術に関する研究 : 第1報,定常回転時に羽根に生じる応力の発生メカニズム
- テープと接触するヘッドの摩耗形状に関する研究 : 第2報, 解析法の検討
- テープと接触するヘッドの摩耗形状に関する研究 : 第1報, 実験的検討
- 多翼ファンの設計技術に関する研究 : 第2報,軸系のねじり振動モデルの基礎的検討
- 期待される新エネルギー
- デザインテクノロジーの必要性
- 超伝導材料, 堂山昌男, 山本良一(編), 伊原英雄, 戸叶一正(著), 1987年, 東京大学出版会発行, A5判, 350ページ, 3200円
- 1986年, Kokon Shoin発行, 150x230mm, 897ページ, 20,000円(粉体小特集)
- 設計のエキスパート化に伴う材料強度評価技術の在り方
- 325 回転機固定子巻線用含浸レジンの接着強度の半実験的解析法による検討