ペダリング運動時の下肢関節トルクにおけるサイクリストと非サイクリストの比較

概要

論文の詳細を見る
The purpose of this study was to compare the effect between cyclists and noncyclists of pedal rates on ankle, knee, and hip joint torque during pedaling exercises.Six male cyclists (CY) and seven male noncyclists (NC) pedaled at 40, 60, 90 and 120 rpm with a power output of 200W.The lower limb was modeled as three rigid segment links constrained to plane motion.Based on the Newton-Euler method, the equation for each segment was constructed and solved on a computer using pedal force, pedal, crank, and lower limb position data to calculate torque at the ankle, knee, and hip joints.The average planter flexor torque decreased with increasing pedal rates in both groups.The average knee extensor torque for CY decreased up to 90 rpm, and then leveled off at 120 rpm.These results were similar to NC.The average knee flexor torque in both groups remained steady over all pedal rates.The average hip extensor torque for CY decreased significantly up to 90 rpm where it showed the lowest value, but increased at 120 rpm.For NC, the average hip extensor torque did not decrease at 90 rpm compared with 60 rpm, and was significantly higher than CY at 120 rpm(CY:28.1±9.0Nm, NC:38.6±6.7Nm, p<0.05).The average hip flexsor torque for NC at 120 rpm increased significanly from 90 rpm, and was significantly higher than CY(CY:11.6±2.9Nm, NC:22.6±11.8Nm, p<0.05).These results suggest that it would be better for cyclists to select a pedal rate of between 90 to 110 rpm to minimize joint torque, and, as a result, reduce peripheral muscle fatigue.
日本体力医学会の論文
1999-10-01

ペダリング運動時の下肢関節トルクにおけるサイクリストと非サイクリストの比較

スポンサーリンク

概要

著者

関連論文

スポンサーリンク