浸炭歯車の歯面の改善と面圧強度に関する研究 (第3報) : 油膜形成に及ぼす歯面仕上げの影響
スポンサーリンク
概要
- 論文の詳細を見る
It is very difficult to finish precisely the surface roughness of gear tooth to the extent of a few sub-micron meters by a grinding machine. Even if it is possible, a time for grinding tooth will be very long and a grinding burn may often occur. The authors have adopted a barreling process as a last finish process for improvement of the suface roughness of the ground or the shot peened gears. And they found tbat this process is very effective for improving only the suface roughness of gear tooth which may have a slightly tooth tip relief and/or crowning. In the present research, four kinds of gears which are the ground gear, the ground and shot peened one, the ground, shot peened and barreled one, and the shot peened and barreled one without grinding were prepared. Their suface durabilities were investigated using a gear testing machine which can measure the condition of oil film formation between a pair of gears during running. Though the tooth profile of the ground, shot peened and barreled gear did scarcely change after running, that of the ground and shot peened one changed remarkably. The duration of the oil film formation in a running test conducted using barreled gears was very good, but that of the ground and shot peened gears was very bad.
- 公益社団法人精密工学会の論文
- 2000-09-05
著者
関連論文
- WWW上の教材を活用した調べ学習と問題解決学習
- 社会人対象のデジタルコンテンツ・クリエーター育成プログラムの実践
- オンライン学習大学ネットワークにおける教材配信システムの開発 (特集 リメディアル教育とICT)
- MoodleとXOOPSを基盤とし大学の要求を考慮した学習管理システムの開発と運用(教育支援,ユーザ指向の分散システム/インターネットの運用・管理)
- eラーニングコンテンツの制作と多分野での利用について (特集 e-Learningにおける高等教育機関の質保証への取り組み)
- 6-220 eラーニングを用いた初年次教育における環境教育環境の構築((11)e-ラーニング-II,口頭発表論文)
- 1322 IPv6を用いた工作機械の遠隔操作に関する研究 : 第3報遠隔操作の方法と評価(GS-13 生産加工・生産システム(3))
- 浸炭歯車の歯面の改善と面圧郷土に関する研究 : ローラによる基礎実験結果
- 1006 IPv6を用いた工作機械の遠隔操作に関する研究 : 第2報 遠隔における位置決め操作について(生産加工・工作機械II,生産システムI)
- IPv6を用いた遠隔機械制御システムの開発(一般セッションII)