A Differential Input/Output Linear MOS Transconductor
スポンサーリンク
概要
- 論文の詳細を見る
In this paper, a differential input/output linear MOS transconductor using an adaptively biasing technique is proposed. The proposed transconductor based on a differential pair is linearized by employing an adaptively biasing circuit. The linear characteristic of the individual differential output currents are obtained by introducing the adaptively biased currents to terminate the differential output terminals. Using the proposed technique, the common-mode rejection ration (CMRR) becomes high. Simulation results show that the proposed technique is effective for improvement of the linearity and other performances.
- (社)電子情報通信学会の論文
- 2011-06-01
著者
-
Takeuchi Hitoshi
Department Of Surgery Iwakuni National Hospital
-
Matsumoto Fujihiko
Department Of Applied Physics National Defense Academy
-
Ohbuchi Takeshi
Department Of Applied Physics National Defense Academy
-
TONGPOON Pravit
Department of Applied Physics, National Defense Academy
-
Tongpoon Pravit
Department Of Applied Physics National Defense Academy
-
Takeuchi Hitoshi
Department Of Applied Physics National Defense Academy
関連論文
- Evaluation of an Estimation of Physiologic Ability and Surgical Stress (E-PASS) Scoring System to Predict Postoperative Risk : A Multicenter Prospective Study
- Crosstalk Simulation for Parallel Microstrip Lines with a Nonlinear Capacitive Load Using the Dynamic C-V Characteristic
- Confirmation of the Distribution of Measured Values from an Ultrasound Fetal Heart Rate Monitor
- Ultrasound Doppler Sinusoidal Shift Signal Analysis by Time-Frequency Distribution with New Kernel
- A Technique to Reduce Power Consumption for a Linear Transconductor(Analog Circuit and Device Technologies)
- Current Feedforward Phase Compensation Technique for an Integrator and Its Application to an Auto-Compensation System(Special Section on Papers Selected from ITC-CSCC 2001)
- Heart Rate Simulation with IPFM Model Considering Absolute Refractory Period and Demodulation of Original Generating Function
- A 1-V Continuous-Time Filter Using Bipolar Pseudo-Differential Transconductors (Special Section of Papers Selected from ITC-CSCC '98)
- Low-Voltage Linear Bipolar OTAs Employing Hyperbolic Circuits with an Intermediate Voltage Terminal(Special Section on Papers Selected from ITC-CSCC 2001)
- Experimental Study on Measurement of Acoustic Cavitation Bubbles in Spatial Frequency Domain Using Optical Spectrometer
- Far-End Crosstalk Voltage for a CMOS-IC Inverter Load(Special Section on Papers Selected from ITC-CSCC 2002)
- Realization of a Precise Voltage Divider with High Input Resistance for a Triple-Tail Cell in a Gyrator-C Filter
- Time-Frequency Analysis of the Blood Flow Doppler Ultrasound Signal
- Mixed Duct-Acinar-Islet Cell Tumor of the Pancreas : Report of a Case
- Colon Carcinoma After Thymectomy for Myasthenia Gravis : Report of a Case
- A Novel Linearized Transconductor Using a Differential Current Amplifier
- A Differential Input/Output Linear MOS Transconductor
- Evaluation of Acousto-Optic Effect on Size Distribution Measurement of Oscillating Cavitation Bubbles Using Optical Spectrometer
- Manufacture of pure titanium(IV) oxide by the chloride process. III. Precipitation of hydrous titanium(IV) oxide in hydrochloric acid solution at elevated temperatures.
- A Differential Attenuator for Phase Compensation System of Feedback Integrators
- Measurement of Diffraction Pattern Using Two-Dimensional Image Sensor for Obtaining Instantaneous Diameter Distribution of Acoustic Cavitation Bubbles
- Manufacture of pure titanium(IV) oxide by the chloride process. II. Selective extraction of titanium(IV) and iron(III) from hydrochloric acid leach liquor of ilmenite ore by tributyl phosphate.
- Measurement of Diffraction Pattern Using Two-Dimensional Image Sensor for Obtaining Instantaneous Diameter Distribution of Acoustic Cavitation Bubbles