Impact of the Recovery of Secondary Ferrous Materials from Alternative ELV Treatment Methods on CO_2 Emission : A Waste Input Output Analysis
スポンサーリンク
概要
- 論文の詳細を見る
The demand for iron and steel materials has been increasing mainly because of the rapid economic growth of the BRIC countries. The annual worldwide production of crude steel is approximately 2 billion tons. There has been a corresponding increase in the production of crude steel in Japan. As a result, the significance of Japan as a source of iron and steel scraps has also increased.1)Scrap recycling, however, is subject to some problems, such as unstable supply conditions and contamination by impurities.2) A significant part of these problems can be attributed to the increasing use of electric devices, such as circuit boards, motors, and wiring harnesses, in high-tech products. These electric devices/equipments contain many kinds of metals, such as copper, lead, and zinc, which can become a source of contamination of steel scrap recovered from end-of-life vehicles (ELVs) or home appliances.Here the contamination of tramp elements was analyzed using a Waste Input Output model, considering the following points: (1) the amount of ferrous scrap usage in iron and steel production process, (2) copper elimination from ELV scraps, and (3) contamination of copper in iron and steel products.The results of scenario analysis indicated that copper contamination in crude steel production associated with the use of scrap from ELVs could be reduced by 2% by the use of a more recycle-oriented ELV treatment. The effects of copper elimination on CO2 emission were more significant for ordinary steel production than special steel production.
- 2011-01-15
著者
-
NAKAJIMA Kenichi
National Institute for Environmental Studies
-
Nakamura Shinichiro
Waseda University
-
Nagasaka Tetsuya
Graduate School Of Environmental Studies Tohoku University
-
Nagasaka Tetsuya
Graduate School Of Engineering Tohoku University
-
MATSUBAE Kazuyo
Graduate School of Environmental Studies, Tohoku University
-
Matsubae-yokoyama Kazuyo
Graduate School Of Environmental Studies Tohoku University
-
NAGASAKA Tetsuya
Graduate School of Engineering, Tohoku University
関連論文
- Evaluation of Total Materials Requirement for the Recycling of Elements and Materials (Urban Ore TMR) from End-of-Life Electric Home Appliances
- Preparation of N-Doped TiO_x Films as Photocatalyst Using Reactive Sputtering with Dry Air
- Novel Evaluation Method of Elemental Recyclability from Urban Mine : Concept of Urban Ore TMR
- Evaluation of the Potential Amounts of Dissipated Rare Metals from WEEE in Japan
- Global Flow of Metal Resources in the Used Automobile Trade
- Outflow of Resources from Japan focusing on End-of-life Vehicles
- Waste Input-Output Material Flow Analysis of Metals in the Japanese Economy
- Breeding of the Silkworm Race "SERICIN FLAVO" for Production of Sericin Cocoons Containing Flavonol
- Phase Equilibria of Two-liquid CaO-MgO-Fe_tO-P_2O_5 Slag Saturated with (Mg, Fe)O
- Equilibrium Relation of Two Liquid CaO-MgO-Fe_tO-P_2O_5 Slag Phases Saturated with (Mg,Fe)O
- Phase Equilibria between SiO_2 and Iron-Chromite Spinel Structure Solid Solution, and Deoxidation of Liquid Fe-Cr Alloy with Silicon
- Thermodynamics of Oxygen in liquid Fe-Cr Alloy Saturated with FeO・Cr_2O_3 Solid Solution
- Dissolution behavior of environmentally regulated elements from steelmaking slag into seawater
- Dissolution behavior of nutrition elements from steelmaking slag into seawater
- Substance Flow Analysis of Manganese Associated with Iron and Steel Flow in Japan
- Substance Flow Analysis of Indium for Flat Panel Displays in Japan
- Material Flow Analysis of Aluminum Dross and Environmental Assessment for Its Recycling Process
- Substance Flow Analysis of Molybdenum Associated with Iron and Steel Flow in Japanese Economy
- Evaluation Method of Metal Resource Recyclability Based on Thermodynamic Analysis
- Equilibrium between Titanium and Oxygen in Liquid Fe-Ti Alloy Coexisted with Titanium Oxides at 1873K
- Surface Roughness of Solidified Mold Flux in Continuous Casting Process
- Substance Flow Analysis of Zinc Associated with Iron and Steel Cycle in Japan, and Environmental Assessment of EAF Dust Recycling Process
- New EAF Dust Treatment Process with the Aid of Strong Magnetic Field
- Waste Input-Output Material Flow Analysis of Metals in the Japanese Economy
- Impact of the Recovery of Secondary Ferrous Materials from Alternative ELV Treatment Methods on CO_2 Emission : A Waste Input Output Analysis
- Separation and Recovery of Phosphorus from Steelmaking Slags with the Aid of a Strong Magnetic Field
- Recycling Effects of Residual Slag after Magnetic Separation for Phosphorus Recovery from Hot Metal Dephosphorization Slag
- Magnetic Separation of Phosphorus Enriched Phase from Multiphase Dephosphorization Slag
- Waste Input-Output Analysis on "Landfill Mining Activity"
- Effect of Oxygen on the Evaporation Rate of Lead from Liquid Popper under Reduced Pressure
- New Activity Measurement Technique by Vacuum-Sealed Quartz Cell/Atomic Absorption Spectrophotometer Combination and Its Application to Liquid Bi-In Binary System
- Carbonization Behaviour of Woody Biomass and Resulting Metallurgical Coke Properties
- Desulfurization Technology in the Blast Furnace Raceway by MgO-SiO_2 Flux Injection
- ADJUSTMENT COSTS IN STAGNANT AND RAPIDLY GROWING INDUSTRIES
- MULTILATERAL TFP INDEX AND MULTILATERAL SIMILARITY OF TECHNOLOGY
- Micro-structure Refinement in Low Carbon High Manganese Steels through Ti-Deoxidation, Characterization and Effect of Secondary Deoxidation Particles
- Identifying the Substance Flow of Metals Embedded in Japanese International Trade by Use of Waste Input-Output Material Flow Analysis (WIO-MFA) Model