A New Model for the Prediction of Roll Force and Tension Profiles in Flat Rolling
スポンサーリンク
概要
- 論文の詳細を見る
This paper presents a precision on-line model for the prediction of the roll force and tension distributions across the strip in hot strip rolling. The approach is based on an approximate 3-D theory of rolling, and in particular, considers the effect of pre-deformation of the strip, which occurs near the roll entrance before the strip enters the bite zone. The prediction accuracy of the proposed model is examined through comparison with the predictions from the 3-D finite element models.
- 社団法人 日本鉄鋼協会の論文
- 2010-11-15
著者
-
SHIN T.
Department of Veterinary Medicine, Institute for Life Science, Cheju National University
-
Hwang S.
Department Of Mechanical Engineering Pohang University Of Science And Technology
-
Kim Y.
Department Of Conservative Dentistry School Of Dentistry Kyungpook National University
-
Hwang S.
Department Of Electrical Engineering And Graduate Institute Of Electronic Engineering National Taiwa
-
Kim Y.
Department Of Mechanical Engineering Pohang University Of Science And Technology
-
KWAK W.
Rolling Technology & Process Control Research Group, POSCO Technical Research Laboratories
-
Kwak W.
Rolling Technology & Process Control Research Group Posco Technical Research Laboratories
-
Kim Y.
Department Of Chemical And Biomolecular Engineering Kaist
関連論文
- Surface Hardening Treatment for Titanium Materials Using Ar-5%CO Gas in Combination with Post Heat Treatment under Vacuum
- Magnetic capture of a single magnetic nanoparticle using nano-electromagnets
- Investigation of the Thermo-mechanical Behavior of Type 304 Stainless Slab in Hot Charge Rolling Condition by the Finite Element Method
- 豚エンテロウイルス血清型3感染豚の心嚢病変部におけるinducible nitric oxide synthase(iNOS)とnitrotyrosine陽性細胞の検出(病理学)
- High-Temperature Mechanical Properties and Structural Change in Amorphous Al-Ni-Fe-Nd Alloys
- CERTAIN CLASSES AND INEQUALITIES INVOLVING FRACTIONAL CALCULUS AND MULTIVALENT FUNCTIONS (Inequalities in Univalent Function Theory and Its Applications)
- P-IS-81 Outcome of pregnancies with preterm premature rupture of membranes(Perinatology 3,Group 108,International Session)
- UNUSUAL CORROSION PRODUCT IN FAILED TOTAL HIP ARTHROPLASTIES
- Surface Hardening Treatment for C.P. Titanium and Titanium Alloys in Use of Ar-5%CO Gas
- Enhanced Electroluminescence of Polymer Light-Emitting Diodes with Direct Polyaniline Synthesized Anodes
- In vitro Remineralization of Severely Compromised Bonded Dentin
- Failure of a Glass Ionomer to Remineralize Apatite-depleted Dentin
- IPN (INTERPENETRATING POLYMER NETWORK) MATERIALS WITH CONTROLLED MORPHOLOGY
- Staurosporine Mobilizes Ca^2+ from Secretory Granules by Inhibiting Protein Kinase C in Rat Submandibular Acinar Cells
- ANALYSIS OF 1,129 CONSECUTIVE PATIENTS WITH ACUTE STROKE : THE HALLYM STROKE REGISTRY
- IS-17 Dection of high risk type human papilloma viruses(16,18) in tissues of cervical lesion using polymerase chain reaction in situ hybridization
- 20-P2-CJK21 New Guideline for Inspection of Anticancer Drug Prescription
- A Finite Element Model for the Prediction of Thermal and Metallurgical Behavior of Strip on Run-out-table in Hot Rolling
- AMPK Attenuates Bupivacaine-induced Neurotoxicity
- Dosimetry of Ho-166 Balloon Catheter Using GafChromic Film
- Prediction of Three Dimensional Strip Temperatures through the Entire Finishing Mill in Hot Strip Rolling by Finite Element Method
- An Integrated FE Process Model for the Prediction of Strip Profile in Flat Rolling
- A New Model for the Prediction of Roll Force and Tension Profiles in Flat Rolling
- Effect of Microstructure on the Yield Ratio and Low Temperature Toughness of Linepipe Steels
- Thermal Mechanisms of Grain and Packet Refinement in an Lath Martensitic Steel
- Finite Element Modeling of Thermo-mechanical and Metallurgical Behavior of Type 304 Stainless Steel in Cold Strip Rolling
- Dimensional Analysis of Hot Strip Rolling for On-line Prediction of Thermo-mechanical Behavior of Roll-Strip System
- Histopathological changes of embryonic chick heart in teratologic experiment by trichloroethylene : Abstracts of Papers Presented at the Thirty-First Annual Meeting of the Japanese Teratology Society Izumo, Japan, July 11-12, 1991
- Fabrication and Beta-Ray Source Test of Double-Sided Silicon Strip Sensor
- X-ray Micro-Imaging of Flows in Opaque Conduits
- Annealing Effect of Magnetic Properties in Co_Nb_x Thin Films
- High Temperature Oxidation of TiAl/SiC_p Composites Manufactured by MA-SPS Process
- Synthesis and characterization of high temperature stable epoxy adhesive
- COLORS OF THE FOUR ELEMENTS IN RELATION TO THE ECOLOGY(Special Issue 37th Annual Meeting)
- O-60 IS PORTAL VENOUS DECOMPRESSION NECESSARY DURING HEPATECTOMY UNDER PROLONGED INFLOW OCCLUSION?
- Nanoscale Strained Si/SiGe Heterojunction Tri-gate FETs
- Branch-Line Couplers Using Defected Ground Structure(Devices/Circuits for Communications)
- Ultrasonic measurement of the embryonic heart in teratogenic experiments : The 35th Annual Meeting of the Japanese Teratology Society
- Real time changes of images observed in cardiac teratogenic experiment using trichloroethylene by ultrafine flexible endoscope : Abstracts of Papers Presented at the Thirty-Third Annual Meeting of the Japanese Teratology Society Nagoya, Japan, July 21-23,
- Vitamin B_ treatment for delayed sleep phase syndrome : A multi-center double-blind study
- [Invited] Is quantum entanglement invariant in special relativity? (AWAD2003 (Asia-Pacific Workshop on Fundamental and Application of Advanced Semiconductor Devices))
- Characteristics of ANS responses to pleasant and unpleasant emotions induced by visual stimulus(Proceedings of the 7th International Congress of Physiological Anthropology)
- Invited Is quantum entanglement invariant in special relativity? (先端デバイスの基礎と応用に関するアジアワークショップ)
- Biomimetic Analogs for Collagen Biomineralization
- Organic Thin-Film Transistors Based on Vapor-Deposition Polymerized Gate Insulators