Calculation of Electromagnetic Field Emitted from UTP Cable by Moment Method from 0.3GHz to 2GHz
スポンサーリンク
概要
- 論文の詳細を見る
The electromagnetic field emitted from UTP cable has been calculated by the 4-port network method from 30 MHz to 1 GHz. However it has not been clarified as to whether this method was effective in the frequency range of more than 1 GHz or not. In this paper, the electromagnetic field emitted from UTP cable was calculated by the moment method and it was compared with the calculated results by the 4-port network method. The wire grid model was developed to represent the propagation constants of UTP cable. The comparison of calculated and measured results confirms the validity of the model. A hybrid coupler was used to generate differential mode signal for the measurement. The comparison indicated that the calculated results by the moment method closely agreed with the measured results in the frequency range of 0.3 to 2 GHz and the difference was smaller than the results by the 4-port network method.
- 社団法人電子情報通信学会の論文
- 2009-06-01
著者
-
KUWABARA Nobuo
Kyusyu Institute of Technology
-
Kuwabara Nobuo
Department Of Electrical Engineering Kyushu Institute Of Technology
-
KUWABARA Nobuo
Dept. of Electrical Engineering and Electronics, Kyushu Institute of Technology
-
ISHIDA Yasuhiro
Fukuoka Industrial Technology Center
-
KAWABATA Masato
Fukuoka Industrial Technology Center
-
Kuwabara Nobuo
Dept. Of Electrical Engineering And Electronics Kyushu Institute Of Technology
-
Kuwabara Nobuo
Kyushu Institude Of Technology
関連論文
- Effect of PLC Signal Induced into VDSL System by Conductive Coupling
- Calculation of longitudinal conversion loss and input impedance for indoor AC mains line considering high-speed PLC
- Calculation of Electromagnetic Field Emitted from UTP Cable by Moment Method from 0.3GHz to 2GHz
- Macroscopic visualization of a radiated emission source using cylindrically scanned electric field amplitude data
- Comparison of site attenuation analysis results between FDTD and ray-tracing method using compact anechoic chamber
- Finding Method of Radiated Emission Sources with Arbitrary Directional Current Components Utilizing CISPR Measurement System
- Estimation of Horizontally Polarized Radiated Emission Sources Based on CISPR Measurement System(Special Issue on Recent Progress in Electromagnetic Compatibility Technology)
- Investigation of Radiated Emission Characteristics of Balanced Cable by Using Analysis Method that Takes a Balance-Unbalance Conversion Factor into Consideration
- Effect of PLC Signal Induced into VDSL System by Conductive Coupling
- Method of Evaluating Shielding Effect of Enclosure Using Disc-Cone Antenna Operated by O/E Converter from 1GHz to 8GHz