Development of Fine-Grained Structure Caused by Friction Stir Welding Process of a ZK60A Magnesium Alloy
スポンサーリンク
概要
- 論文の詳細を見る
- Japan Institute of Metalsの論文
- 2009-03-01
著者
-
MOTOHASHI Yoshinobu
Research Center for Superplasticity, Ibaraki University
-
Somekawa Hidetoshi
Structural Metals Center National Inst. For Materials Sci.
-
Somekawa Hidetoshi
Structural Metals Center National Institute For Materials Science
-
Somekawa Hidetoshi
National Institute For Materials Science
-
Mironov Sergey
Research Center For Superplasticity Faculty Of Engineering Ibaraki University
-
KAIBYSHEV Rustam
Centre of Nanostructured Materials and Nanotechnologies, Belgorod State University
-
MUKAI Toshiji
National Institute for Materials Science
-
TSUZAKI Kaneaki
National Institute for Materials Science
-
Motohashi Yoshinobu
Research Center For Superplasticity Faculty Of Engineering Ibaraki University
-
Kaibyshev Rustam
Centre Of Nanostructured Materials And Nanotechnologies Belgorod State University
-
Tsuzaki Kaneaki
Structural Metals Center National Inst. For Materials Sci.
-
Tsuzaki Kaneaki
Steel Research Center National Inst. For Materials Science (nims)
-
Tsuzaki Kaneaki
Structural Metals Center National Institute For Materials Science
-
Tsuzaki Kaneaki
Doctoral Program In Materials Science And Engineering University Of Tsukuba
-
Tsuzaki Kaneaki
Steel Research Center National Institute For Materials Science
-
Tsuzaki Kaneaki
National Institute For Materials Science Tsukuba
-
Tsuzaki Kaneaki
Frontier Research Center For Structural Materials National Institute For Materials Science
-
Tsuzaki Kaneaki
Frontier Research Center For Structural Materials National Research Institute For Metals
関連論文
- Influence of Flat Cavity Formation on Stress vs. Strain and Strain-Rate Relations of Superplastic Deformation in 3Y-TZP
- Effect of Ultrasonic Vibration Pretreatment on Microstructural Evolution and Mechanical Properties of Extruded AZ91 Alloy
- High Strength and Fracture Toughness Balances in Extruded Mg-Zn-RE Alloys by Dispersion of Quasicrystalline Phase Particles
- Determination of Hydrogen Desorption Activation Energy by a Single TDS Spectrum
- Hydrogen Trapping in Quenched and Tempered 0.42C-0.30Ti Steel Containing Bimodally Dispersed TiC Particles
- Hydrogen Trapping in Quenched and Tempered 0.42C-0.30Ti Steel Containing Bimodal Dispersions of TiC Particles
- Polarization Behavior of Pure Magnesium under a Controlled Flow in a NaCl Solution
- Fatigue Behaviors and Microstructures in an Extruded Mg-Al-Zn Alloy
- Effect of Hydrogen Content on Fracture Stress for High Strength Steel
- Fracture Toughness in an Extruded ZK60 Magnesium Alloy
- Development of Fine-Grained Structure Caused by Friction Stir Welding Process of a ZK60A Magnesium Alloy
- Structural Response of a ZK60 Magnesium Alloy Subjected to Friction Stir Welding(Synergy by Microstructuring)
- A New Evaluation Method of Hydrogen Embrittlement Fracture for High Strength Steel by Local Approach
- Evaluation of hydrogen embrittlement susceptibility for high strength steels with Local Approach by considering hydrogen distribution : Examination for estimation of delayed fracture properties-11
- Regularities of Deformation Microstructures in Ferritic Stainless Steels during Large Strain Cold Working
- Microstructure Evolution in Ferritic Stainless Steels during Large Strain Deformation
- Effect of Nano-Sized Oxides on Annealing Behaviour of Ultrafine Grained Steels
- High Resolution Electron Microscopy Study of Cementite in Tempered Martensite
- Synergetic Effect of Grain Refinement and Spherical Shaped Precipitate Dispersions in Fracture Toughness of a Mg-Zn-Zr Alloy
- Delamination Toughening of Ultrafine Grain Structure Steels Processed through Tempforming at Elevated Temperatures
- Feasibility of Friction Stir Welding for Joining and Microstructure Refinement in a ZK60 Magnesium Alloy
- Development of Die Press-fitted with Die Holder Made of Al Alloy for Compacting Metal Powders
- Evaluation of Compressibility and Ejection Force Using a Tapered Die : Effects of Different Types of Die Wall on Compacted Metal Powders II
- Effects of Different Types of Die Wall on Compacted Metal Powders
- Comparison among SANS Technique and Conventional Methods for Cavity Characterization in Superplastically Deformed Ceramic
- Friction Stir Welding of a Commercial 7075-T6 Aluminum Alloy : Grain Refinement, Thermal Stability and Tensile Properties
- Flat Cavities formed in TZP caused by Superplastic Deformations at High Strain-Rates and Their Effect on Elongation
- Superplastic Response of an Advanced Al-Li-Mg-Cu-Sc Alloy Subjected to Intense Plastic Deformation
- Superplastic Behavior in Al-Li-Mg-Cu-Sc Alloy Sheet
- Effect of Superplastic Deformation on Thermal Expansion Behavior of Tetragonal Zirconia Polycrystals
- Characterization of Cavities in Superplastically Deformed Tetragonal Zirconia Polycrystals by Means of Small Angle Neutron Scattering
- Thermal Conductivity of Superplastically Deformed 3Y-TZP
- Distributions of Hardness and Strain during Compression in Pure Aluminum Processed with Equal-Channel Angular Pressing and Subsequent Annealing
- Slip System Partitioning as a Possible Mechanism for Ultrafine Grain Formation in Fe-3%Si Bicrystals
- Hydrogen Entry in Crevice Region : Evaluation by Hydrogen Permeation Technique
- Preface to the Special Issue on "Recrystallization and Related Phenomena"
- Nanoindentation-Induced Deformation Behavior in the Vicinity of Single Grain Boundary of Interstitial-Free Steel
- Development of Shrinkage-Fit Die Coated with Film Possessing Low Friction Coefficient for Compacting Metal Powders
- Effect of Heat Treatment on TEM Microstructures of Zirconium Carbide Coating Layer in Fuel Particle for Advanced High Temperature Gas Cooled Reactor
- Evaluation of Grain Boundary Effect on Strength of Fe-C Low Alloy Martensitic Steels by Nanoindentation Technique
- OS6(2)-6(OS06W0420) Nanoindentation Technique as a Probe for Characteristic Deformation Size
- Effect of Contact Depth on Nanohardness Distribution in a SCM440 Tempered Martensitic Steel
- Enhancement of Impact Toughness of 0.05% P Doped High Strength Steel through Formation of an Ultrafine Elongated Grain Structure
- Effects of Neutron Irradiation on Some Superplastic Characteristics of Tetragonal Zirconia Polycrystals Containing 3mol% Yttria
- Coherent-to-Incoherent Transition of Intergranular bcc-precipitates by Pre-/Post-deformations in a Ni-43Cr Alloy
- Effect of Quasicrystal Phase Particle Dispersion on Mechanical Properties in Mg-Zn-Al Alloys
- Effects of Superplastic Deformation on Dynamic Hardness and Young's Modulus of 3Y-TZP(Mechanical Behavior of Materials 2)
- Microstructural Analyses of Grain Boundary Carbides of Tempered Martensite in Medium-Carbon Steel by Atomic Force Microscopy
- Preface to the Special Issue on "Abvanced Structural Steels"
- Preface to the Special Issue on "Advances in Physical Metallurgy and Processing of Steels"
- PREFACE
- A study of variant selection of bcc phase formed from slightly work-hardened fcc matrix in Ni-Cr alloy
- Influence of Processing Regimes on Fine-Grained Microstructure Development in an Al-Mg-Sc Alloy by Hot Equal-Channel Angular Pressing
- Effect of Dislocation Density on the Initiation of Plastic Deformation on Fe-C Steels
- Quasi-cleavage Fracture along Annealing Twin Boundaries in a Fe-Mn-C Austenitic Steel
- Hydrogen Embrittlement in Al-added Twinning-induced Plasticity Steels Evaluated by Tensile Tests during Hydrogen Charging
- Machinability Improvement and Its Mechanism in SUS304 Austenitic Stainless Steel by Precipitated Hexagonal Boron Nitride
- TWIP Effect and Plastic Instability Condition in an Fe–Mn–C Austenitic Steel
- TWIP Effect and Plastic Instability Condition in an Fe-Mn-C Austenitic Steel
- Hydrogen Embrittlement in Al-added Twinning-induced Plasticity Steels Evaluated by Tensile Tests during Hydrogen Charging