Ejection of small sedimentary particles into a cylindrical bath by swirl motion of bubbling jet (特集 流動の可視化)
スポンサーリンク
概要
- 論文の詳細を見る
- 日本実験力学会の論文
- 2007-12-25
著者
-
Sasaki Yasushi
Graduate Institute of Ferrous Technology (GIFT), Pohang University of Science and Technology (POSTEC
-
IGUCHI Manabu
Graduate School of Engineering, Hokkaido University
-
Iguchi Manabu
Graduate School Of Engineering Hokkaido University
-
Sasaki Yasushi
Graduate Inst. Of Ferrous Technol. (gift) Pohang Univ. Of Sci. And Technol. (postech)
-
FUJIKAWA Toshihide
Graduate School of Engineering, Hokkaido University
-
FUKUE Masaharu
Graduate School of Marine Science and Technology, Tokai University
-
Fukue Masaharu
Graduate School Of Marine Science And Technology Tokai University
-
Fujikawa Toshihide
Graduate School Of Engineering Hokkaido University
-
Iguchi Manabu
Graduate School Of Engineering Hokkaido Univ.
関連論文
- Formation of Calcium Ferrites under Controlled Oxygen Potentials at 1273 K
- Frequency of Bubble Formation from a Multi-Hole Nozzle Attached to a Top Lance
- Bubble Formation from a Two-Hole Nozzle Attached to a Top Lance
- Model experiment on the hydrodynamic drag of a poorly wetted sphere penetrating into a molten metal bath (特集 機械の流れ)
- Bubble Formation Frequency at a Single-hole Nozzle Immersed in a Mercury Bath
- Solid-Liquid Separation in Wastewater by Air Bubble : Bubble Formation Frequency at Poorly Wetted Nozzle
- Transition to Turbulence in Constant Velocity Pipe Flow after Initial Constant-Acceleration
- Study of Noise Reduction in Cross Flow Fans with Annular Bands
- Coanda effect on bubble characteristics in a bubbling jet rising nearthe side wall of a cylindricalvessel
- Tailoring and Measurements of Unsteady Pipe Flow
- Critical Reynolds Number in Constant-Acceleration Square Duct Flow
- Flow Rate Measurement in Unsteady Pipe Flow through a Plate Orifice
- Prediction of the Occurrence of Swirling Liquid Jet Generated by Off-centered Nozzle
- Development of Swirling Flow Generator in Immersion Nozzle
- Swirling Flow Effect in Immersion Nozzle on Flow in Slab Continuous Casting Mold
- Development of a Method of Nitrate Nitrogen Treatment using Catalyst Particles and Reaction Gas
- The Coordination of F Ions around Mg and Ca Ions in Molten CaO–CaF2–MgO–SiO2 System at 1873K
- Self-Induced Rotary Sloshing Caused by an Upward Off-Centered Jet in a Cylindrical Container
- Swirl Motion of a Mercury Jet Appearing in a Cylindrical Vessel in Transient Period
- Swirl motion of a water jet in a water bath of linearly increasing depth (特集 流動の可視化)
- EFFECT OF LOW-DENSITY PARTICLES ON SWIRLING LIQUID JET IN TRANSIENT PERIOD
- The Coordination of F Ions around Al and Ca Ions in Molten Aluminosilicate Systems
- The Role of Ca and Na Ions in the Effect of F Ion on Silicate Polymerization in Molten Silicate System
- The Estimation of the Iso-viscosity Lines in Molten CaF2–CaO–SiO2 System
- Occurrence Condition of a Swirling Bubbling Jet in a Water Bath Covered with an Oil Layer
- PRACTICAL APPLICATIONS OF SWIRLING JETS TO MIXING PROCESSES(Swirling Flow and Separation)
- FUNDAMENTAL CHARACTERISTICS OF SWIRLING JETS IN CYLINDRICAL VESSEL(Swirling Flow and Separation)
- Prediction of the Occurrence of Swirl Motion at Interface between Stratified Two Liquids
- Stress Relaxation Behavior with Molten CaO-SiO_2-Al_2O_3 Slag
- The Effect of Grain Boundaries on the Surface Rearrangement during Wustite Reduction within its Range of Existence
- Measuring Strains for Hematite Phase in Sinter by Electron Backscattering Diffraction Method
- The Effect of Grain Boundaries on Iron Nucleation during Wustite Reduction Process
- Rupture Phenomena of Molten Alkali Silicate Thin Films
- Rupture phenomena of molten alkali silicate thinfilms
- The Role of Molten Slag in Iron Melting Process for the Direct Contact Carburization: Wetting and Separation
- Simulation of Effect of Pore Structure on Coke Strength Using 3-dimensional Discrete Element Method
- Reply to “Discussion on the Estimation of the Iso-viscosity Lines in Molten CaF2–CaO–SiO2 System”
- The Surface Structure Correlation with the Wustite Surface Rearrangement
- The Effect of Grain Boundary on the Wustite Reduction Process
- The Surface Structure Correlations with the Iron Nucleation in the Wustite Reduction
- The Surface Structure Correlations with Wustite Reduction Mechanism
- Carbonation Reaction of CaO in Jet Milling of CO2 Gas
- The Role of Iron Oxide Bearing Molten Slag in Iron Melting Process for the Direct Contact Carburization
- Occurrence Condition for a Swirl Motion of a Bath Agitated by Bottom Gas Injection
- Effect of Density of Low-Density Particles on Their Dispersion Behavior under Mechanical Agitation
- EFFECT OF LOW DENSITY PARTICLES ON INCLINED-VORTEX FORMATION UNDER MECHANICAL OFFSET AGITATION
- Processing of Refractory Organic Waste Water Using Ozone and Novel Agitation Method
- Swirling Flow Effect in Off-center Immersion Nozzle on Bulk Flow in Billet Continuous Casting Mold
- Swirling Flow Effect in Submerged Entry Nozzle on Bulk Flow in High Throughput Slab Continuous Casting Mold
- Powder-Metallurgical Free-Form Microchanneling Process for Producing Metallic Microreactors
- Powder-Metallurgical Process for Producing Metallic Microchannel Devices
- Swirling Flow Effect in Bottomless Immersion Nozzle on Bulk Flow in High Throghput Slab Continuous Casting Mold
- Swirling flow control in immersion nozzle for Continuous Casting process
- Swirling flow control in immersion nozzle for CC process
- Effects of Channel Gap and Channel Attitude on Flow Pattern of Air-water Two-phase Flow in Rectangular Millimeter-scale Channels
- Effect of Initial Acceleration History on Transition to Turbulence in Pipe Flow
- Behavior of a Droplet on an Inclined Plate under Various Wettability Conditions
- Effects of Inner Nozzle Diameter and Hole Diameter on the Frequency of Bubble Formation from a Multi-hole Nozzle
- Microchanneling and Lining Layer Formation by Spontaneous Infiltration in Fe-Cu System
- Formation Mechanism of Microchannels and Lining Layers in Sintered Iron Powder Compacts with Copper Sacrificial Cores
- Empirical Equations for Bubble Formation Frequency from Downward-Facing Nozzle with and without Rotating Flow Effects
- Raman Spectroscopic Analysis of Molten Na_2O-NaCl-SiO_2 System
- Occurrence Process of Jet-Induced Rotary Sloshing in a Cylindrical Container
- Water Model Experiments on Mechanical Agitation for Hot Metal Pretreatment Process
- Relationship between Internal Flow and Fan Noise of Cross Flow Fan
- Some Aspects of the Amplitude of Swirl Motion of a Cylindrical Bath Induced by a Liquid Jet
- Gas-Liquid Mass Transfer in Simulated Turbulent Wake Flow
- Numerical Simulation on a Horizontal Flow Pattern of Jet-induced Rotary Sloshing in a Cylindrical Container
- Wettability Effect on a Single Bubble Passing through a Plate Orifice Placed in a Vertical Pipe
- Flow Patterns of Gas-Liquid Two-phase Flow through an Abrupt Expansion in Millimeter-Scale Rectangular Channel
- The Preferable Growth Direction of Iron Nuclei on Wustite Surface during Reduction
- Carburization Degree of Iron Nugget Produced by Rapid Heating of Powdery Iron, Iron Oxide in Slag and Carbon Mixture
- Swirl Motion of a Mercury Jet Appearing in a Cylindrical Vessel in Transient Period
- Model Study on a Swirl Motion of a Bubbling Jet Generated in a Wastewater Bath Covered with Top Oil Layer
- Experiment on the Effect of Water Jet upon the Melting Process of an Ice Sphere in a Cylindrical Bath
- A bouncing droplet on an inclined hydrophobic surface
- Repulsive Capillary Force between two Plates Linked by a Concave Molten Slag Bridge
- Ejection of small sedimentary particles into a cylindrical bath by swirl motion of bubbling jet (特集 流動の可視化)
- Prediction of Argon Gas Attachment to Sliding Gate in Immersion Nozzle
- Forward and Backward Reaction Rate Constants of the Reaction of C+O=CO (g) on Fe-C Melts
- Enhancement of Iron Melting Rate under the Co-existence of Graphite and Wustite
- Molecular dynamics analysis of the effect of F on the structure of molten Na_2O-NaF-Al_2O_3-SiO_2 system
- Molecular Dynamics Analysis of Three-dimensional Anionic Structures of Molten Al_2O_3-Na_2O-SiO_2 System
- Simulation of Effect of Pore Structure on Coke Strength Using 3-dimensional Discrete Element Method
- The Role of Molten Slag in Iron Melting Process for the Direct Contact Carburization : Wetting and Separation
- Formation of Calcium Ferrites under Controlled Oxygen Potentials at 1273K
- Fabrication of Ultra High Nitrogen Austenitic Stainless Steel by NH_3 Solution Nitriding
- Development of High Strength Fly Ash Glass-ceramics by Concrete Sludge Addition
- Study on Circular Complex viewed from Environmental Systems : Environmentally-Friendly Cooling Air Drilling Performance
- Prediction of the Period of Swirl Motion Appearing in Gas Injection Processes at High Temperatures
- Mixing Time in a Cylindrical Bath Agitated by Gas Injection through a Multi-hole Nozzle
- Effect of Repeatedly Imposed Acceleration on the Transition to Turbulence in Transient Circular Pipe Flow
- Model study of the effect of slag layer on the swirl motion of molten steel jet (環境特集号(その1))
- Behavior of bubbles attaching to and detaching from solid body of poor wettability
- Behavior of a Droplet Impacting on a Horizontal Plate
- Relationship between Mixing Time and the Number of Holes of a Top Blowing Immersion Nozzle in a Cylindrical Bath
- Air Leakage from Thin-Walled Space between Circular Pipe Flange and Flat Disk
- Swirl Motion in a Cylindrical Bath Agitated by Top Lance Gas Injection
- Flow Past a Square Prism with Cut-Corners (Effect of the Angle of Attack)
- Integral Representation of Low-Reynolds-Number Hydrodynamics (Study of Stokes' Paradox)